|Today 01:02 AM|
|Yesterday 08:55 PM|
|Brian74||I had a similar noise so I brought it to my local mechanic and he discovered the bolts holding the drive shaft came loose. He used loctite and re torqued them . Problem went away. Noise was most noticeable between 3rd -4th when I got on the gas.|
|Yesterday 08:35 PM|
|Yesterday 08:28 PM|
|5doughboy82||Ok I have a 2013 Wrangler Sport with 6 speed manual trans. Took it to my local service department (still under warranty only 11,000 mile) for the marble noise. They couldn't figure it out and pulled trans. and opened it up and said a defective transmission. So they tried to order one and told me the OE part number was no good and they would have to get one off the assemble line and now its been 7 weeks and they still don't have a ETA on the Transmission. Is anybody else having this problem|
|Yesterday 08:20 PM|
I might have a problem?
I might have a transmission problem on a 6 day old JK
I picked up my JK on Saturday morning and spent the weekend racking up 302km of easy driving to break in the engine. I only drove it for short trips the last four days and no off roading other than trying out 4H and 4L in a gravel parking lot. I have been very impressed with the transmission, smoother than I was expecting and have really been enjoying it, until tonight that is.
I had just turned right onto a country road and shifted from second to third at a touch under 3000RPM then got off the accelerator because a pedestrian was crossing the road. When I got back on the accelerator and shifted into fourth the transmission didn't feel right. Now it feels notchy and not nearly as smooth as it has been since I picked it up. It shifted very smooth before but now has a definite mechanical noise and there is a slight resistance when going into gear that wasn't there before.
This really sucks as it's the start of a long weekend and I'm not sure if I should just park it for the weekend or drive it to see if it gets worse or better? I already have an appointment scheduled for Monday morning to have my new Duratracs put on but this could ruin my whole weekend.
Anyone know what this might be? Am I over reacting? It still drives fine but something just doesn't seem right.
|04-14-2014 10:58 AM|
Like a couple others, just get slight marble noise in 3rd when accelerating..
1700 miles now, started @ 1k. Not worried about it yet, shifts smooth..
|04-14-2014 09:24 AM|
|bimmergirl||New throw-out bearing and clutch for me this past week. I had the marbles in a can noise and a thunk/clunk when shifting and now it's gone. Not sure how long it will last though.|
|04-12-2014 12:37 PM|
|keda69||Only have my jeep for a week now, but have over 500 miles on it already. I have driven trucks and sports cars with manuals, and the jeep is definitely like a truck. So if you come from a low clutch grab, and the short shift of a car. The high clutch, long shift, and unrefined feel of the jeep trans will feel "weird" ,but it is perfectly normal for a truck trans. My two cents worth.|
|04-10-2014 06:47 PM|
|04-10-2014 09:59 AM|
My 2013 does and my 2012 did also
My 2013 does and my 2012 did also, in fact I traded the 2012 in for the 2013 because I thought there was something wrong with the transmission after taking it back to the dealer 3 times for the rattling. Both only rattle while idling with the clutch out. If I engage the clutch the rattling stops. I don't experience any other strange noises otherwise. So I'm assuming it's common, that doesn't mean I like it though . Hope this helps!
|04-10-2014 09:45 AM|
|04-10-2014 09:40 AM|
|04-10-2014 09:37 AM|
|Gord P||Just got off the phone with the adviser.... I'm going to have this Ford Escape for a few more days. I'm getting a new transmission. He said that when they opened it up, they found enough wear that they believed it wouldn't be worth the labour and they were able to get authorization for the new unit. I've only put about 3200 miles on it myself since October and I've been easy on it. I suppose, in the long term, going forward with a new transmission is far better than having a repaired original.|
|04-10-2014 07:50 AM|
|04-10-2014 04:29 AM|
|04-09-2014 09:26 PM|
|04-09-2014 08:03 PM|
|Gord P||Mine is a consistent marbles in a can sound in 3rd and 4th once it's warmed up. So, I'm choosing to be optimistic that, based on the shop foreman's confidence in knowing what was happening, the problem will be resolved and all will be right with the world.|
|04-09-2014 03:38 PM|
|04-09-2014 03:24 PM|
|04-09-2014 03:20 PM|
I'll probably eventually take it in, but the thought of tearing my transmission apart to chase down the rattle doesn't thrill me. Especially reading that a new or rebuilt transmission doesn't always solve the problem. I'm waiting to see if it gets any worse, but there's no change after 3 months.
|04-09-2014 01:58 PM|
Indeed, makes me a bit concerned.. However so far I haven't heard anything about complete failures and some people found loose items under the console (x-fer case cable, rubber boot and the like) causing noises that could explain this.
Several people have had parts and entire transmissions replaced and the noise changes (now it's 3-4 at x rpms or the like) or the noise goes away for a little while. Which would make me believe it's not the transmission at all but something else that gets removed/re-attached/moved during removal/installation of the transmission.
Really sounds to me like 'we' are chasing multiple problems. Lots of good suggestions in this thread, if after purchasing I have any noises that seem unusual I'll start with the console 'fixes', change trans oil, check heat shields, etc.. before coming in to the dealer.
|04-09-2014 12:13 PM|
|Gord P||I'm really hoping that this annoyance is resolved. I didn't spend that much money to drive something that sounds like crap.|
|04-09-2014 07:17 AM|
|efm-7||20,000kms now, still no better or worse than before.|
|04-08-2014 06:51 PM|
Had the shop foreman try my 2012 JKU early Saturday morning to check out the marbles in a can sound in 3rd and 4th when the engine is warm. He's confident that he knows what the problem is... I won't embarrass myself by trying to repeat what he said. He did say that he notices the sound goes away when pressing up on the stick in 3rd and down while in 4th. I dropped it off yesterday and I should have it back in a couple days.
I will report back on what they did and the results for those who are experiencing the same issue.
|03-22-2014 10:00 PM|
|Wranglerjoe79||I bought a 2013 new in May. Right now it is at 8500 miles. I noticed that I have a rattle in my shifter when in 2nd gear. It sounds like loose change in my cup holder in the console. I actually noticed this probably 5500 miles ago. I never had time to go to the dealer to get it checked out. I was hoping it would go away. But it has not. If I press harder on the shifter leaver, it goes away. It's more of a vibration rattling sound. I don't know what it is. I'm kinda dreading taking it to the dealer, cause I suspect they'll tell me "it's normal" which would piss me off even more. I also noticed the rattling sound from underneath the jeep. If I press the clutch a little bit, it goes away. I don't know if this only happens when the jeep is warm? To me it sounds like a linkage rattling sound. But I don't know. I only hear when I am actually looking for it. Otherwise I kinda tune it out. Ugh.|
|03-22-2014 06:37 PM|
|keda69||Damn and to think I ordered a manual ,because they usually have less problems then an auto! I haven't even picked my jeep up yet and I'm worried!|
|03-20-2014 11:09 AM|
I read this entire thread before I made my purchase, and again this morning. And, I think your assessment is basically correct. Still, disappointing. Just not yet sure what I want to do about it. The warranty gives me peace of mind atm, and if I do nothing and the noise persists for 5 years without breakage, then I suppose it will not break on day 1 of year 6. Still though, not sure what I want to do.
On some level, this is not dissimilar from some of the trials and tribulations I have had with my 2000 Harley FXST. And that machine was/is not the smoothest/quiet beast by any means.
|03-20-2014 10:56 AM|
|03-20-2014 10:17 AM|
Yesterday I left the 2014 Waiting Room thread, and today I am here ...
68 miles and I have a rattle (marbles in can) in 3rd when accelerating; noise stops with clutch applied or no gas.
4th has a minor rattle when decelerating; no noise when accelerating.
The 3rd gear noise is certainly annoying and disappointing. Not sure I would have even noticed the 4th gear noise if I had not listened for something. No noise in the other gears or neutral. My 10 yo daughter even commented on the 3rd gear noise.
My present plan is to contact the dealer today, and continue to drive for a bit. I want to see if noises change with more time and break-in. Unless I get really aggravated over the next few days, not sure I want to have the dealer tear into it just yet.
I should note that otherwise shifting is reasonably smooth and I am not experiencing any difficult with finding 6th or reverse.
I voted problems even though I have a 2014.
|03-13-2014 01:18 PM|
i had to join the site after reading this thread
I too have the neutral rolling rattle (roll over noise) in tranny , and the grunt at low rpm in neutral around 2000 rpm I think. Its clearly the same noise as some of you have and the shaking shifter shake as your accelerating . I even feel a shudder round 40 mph at steady speed but its def. related I feel .Ive been tracking it down for two years + thinkin it is tranny mount maybe. Some one told me its bad transfer case balancer . But I don't know. I even got new front drive shaft drive . no fix
same exact thing as Blastek has. Just like listening to my jeep by hearing his video
my tranny was pulled at 3000 miles due to bad syncro and fork also
but the roll over noise has been bugging the hell out of me for over 2 years !
|This thread has more than 30 replies. Click here to review the whole thread.|