|Yesterday 06:00 PM|
Foglights.... Going yellow???
What does everyone think about swapping the clears lens/bullbs for yellow ones??? I'm trying to figure out if it's an easy switch or what... Hopefully it's just a matter of popping a new a bulb or lens in. Thanks for all your help
|Yesterday 04:07 PM|
I ran 35's on our stock suspension on road for a few weeks until I got the lift installed and I never rubbed but it was 100% around town road only.
I didn't want to have to replace fenders or trim them if I ever really flexed it out so I went 3". I would imagine that some 2.5 kits may actually get the same lift height I got on the mopar 3" but I didn't measure before and after or at least I didn't write it down in any convenient place if I did. Check the general lift sticky as it will be clear if 35's fit with a 2.5" lift on any other jku.
|Yesterday 08:32 AM|
Doc......somebody suggested to put 35's with 2.5. Lift. Is that feasible or even worth it on our 10th As???
|03-11-2014 11:52 PM|
My only complaint with the teraflex tire carrier is how difficult it is to open and close the gate now. It's really FIRM. my wife is funny as she will open it to put something in and then just leave it open because it's almost too stiff for her 100lb frame to close. I hope that loosens up a bit or maybe I'll call teraflex to see if they have a solution.
The Mopar lift gets criticized for its price but in my calculation you would pay slightly more for the same suspension with adjustable arms and the soeedbumps so I don't see where everyone gets on it for that. I wanted low maintenance arms and I don't plan on changing lift height so see no need for adjustability as long as the arms length has been tuned specifically for this application/kit.
So far I've researched my mods before purchase that I have zero regrets or would do anything differently. Taller would be even more difficult to hop up in, shorter and 35's may require trimmed fenders.
My next steps are brake upgrade and then a couple years or so of enjoyment before I'm willing to pay to play for forced induction. Mine is unabashedly not a full on trail rig but my goal was to make sure that it's fully capable of holding its own for the rare occasion I get out and so far I'd say its successful so far.
|03-11-2014 09:25 PM|
Hey Doc, off topic but wondering how your Stage 3 lift has worked out, wheels/tires, spare tire carrier? I'm still on the fence and your set-up has been what I've been looking at for some time. Thanks.
|03-11-2014 08:03 AM|
430N Voice Commands
I have the 430N in my 10A. when I have an IPOD plugged into the center console USB port I am able to use voice commands to change artist/song. for example I can say "play artist Jimi Hendrix" or "play song stone free" and it works great. but I cant do this with songs on the internal hard drive.
can anyone confirm that voice commands to change artist/song should work with music stored on the internal hard drive?
|03-10-2014 11:24 PM|
|Doctorsti||Heads up to anyone that ordered the HMC billet 10A receiver plug, they ran out of blanks and more are coming in for them to CNC and get shipped out. I wondered why I had not heard anything after sending money 10 days ago but that is the reason for anyone else wondering what might be up.|
|03-10-2014 12:30 PM|
|03-10-2014 08:49 AM|
Hey all. Does anyone know if Anvil is still being produced on the Wrangler line? If not when did it end?
|03-10-2014 07:50 AM|
|03-08-2014 10:44 PM|
You did really good with the camera angles and placement. I can tell you it was tuff finding locations to mount the camera to get a good view of the actions.
|03-08-2014 09:33 PM|
|03-07-2014 09:15 PM|
|jakestgermain||Yes they fit|
|03-07-2014 08:46 PM|
|PA23Sam||Anyone know if the rugged ridge hood latches fit 10a's?|
|03-07-2014 06:10 PM|
Don't skimp - get the Trek Armor ones!
Here is a video I put together on the install, review and tips and tricks you will need to know.
Trek Armor Seat Covers - YouTube
|03-05-2014 06:22 PM|
|unityroad||Sorry about your issues, you may have a badly warped rotor.|
|03-05-2014 06:19 PM|
|03-05-2014 09:30 AM|
|03-05-2014 07:45 AM|
I'll let you know if anything similar shows up because of the gear swap.
|03-05-2014 06:50 AM|
I can easily envision how to make such (clamp thru the rockrails), but as of yet, no one has.
|03-05-2014 06:48 AM|
anyone with auto trans & 4.10 rear axle ?
since day 1 of delivery , I have had :
VIBRATION noise that sounds to be coming from exterior rear of vehicle ,
possibly passenger side rear wheel well ?? not sure ??
VIBRATION occurs when stopping , during the final revolution of the wheel
before stop , ( last couple of feet before stop )
Beside being HEARD ,the VIBRATION is also FELT at the brake pedal , steering wheel ( left hand @ 7 oclock ) and center console ( right arm resting on console )
so far unable to find cause
a friend of mine is supporting a theory that it is the combination
of an automatic transmission with a 4.10 rear axle ratio.
Anyone else experiencing such a VIBRATION that is HEARD & FELT as I do ?
|03-05-2014 06:39 AM|
looking 4 side step that works with stnd rockrails
Anyone know of a side step that works with the standard rockrails
that came on the 10th anniversary edition ?
|03-04-2014 09:12 PM|
|03-03-2014 10:30 PM|
|MrT||1st code P0520 thrown on the 10A. Oil pressure sensor/switch at 9100 miles. Dropped off tonight and hope they'll fix for our weekend trip! Looks like lots of folks seeing this. Dude at the service counter said it could be 3 things.|
|03-03-2014 01:17 PM|
|03-03-2014 01:01 AM|
lol was grocery getting today in the phantom and had a hummer h2 and a anniversary edition Rubicon parked either side of me
the Rubicon had red lettering in the emblems and it looked very very sharp
|03-03-2014 12:42 AM|
|03-02-2014 09:46 PM|
|03-02-2014 08:27 PM|
|ADV.1JK||Update on whether or not the AEV 2" spacer lift works with 35's with the 10A's. I spoke to someone who has a 10A and ran the lift with 35's. He said he has no issues unless he has maximum passengers and gear in his Jeep. In that case he'll get a slight rub when he hits a big dip on the driver rear fender area.|
|02-28-2014 10:42 AM|
|2013 rubiconman||has anyone hit a pot hold at over 50 mph and had esc light come on? last weekend I was behind tracker trailer and hit a pot hold. It mad my sway bar light flicker my abs light flicker and my esc light came on and stayed on till I shut jeep off and back on. Has not done it since than.|
|This thread has more than 30 replies. Click here to review the whole thread.|