|10-03-2009 08:04 PM|
|tincup64||hey mark -many months since your post. i am considering this setup. any issues with rubbing? did you get spacers?|
|05-04-2009 11:37 AM|
Pics, finally :)
Side view- much nicer fender fill
More to follow- my webhosting site is crap Mark W.
Next pic- size matters
|05-02-2009 09:14 AM|
Ok- without spacers, they fit nicely!
Sadly, the stupid StarScan can't compensate for anything but OEM sizes, apparently, so my speedo is a bit off.
Sounds like it's time for a programmer, na? Pics to follow- Mark W.
|05-01-2009 02:44 PM|
|05-01-2009 08:15 AM|
|thaduke2003||^ Thanks. That's what I figured- just pulled the trigger on a set of Rough Country spacers- pics to follow later Mark W.|
|05-01-2009 08:13 AM|
|05-01-2009 06:42 AM|
|05-01-2009 06:22 AM|
|thaduke2003||Bumpity, even though I'll find out today when the tires go on Mark W.|
|04-30-2009 03:10 PM|
Ok- they're Firestone Destination A/T's- overall diameter (according to Tirerack) is 32.8"
So daily driving, on-road, pre-lift, they shouldn't rub? Because I'd HATE to swap over TPMS and get these all ready to rock, then have them rub- my girl would beat me, and not in a good way Mark W.
|04-30-2009 11:23 AM|
You will likely rub hard parts up front at full lock and will need wheel spacers; not a big deal.
Depending on the tires, you'll probably only get 32.3" or so from that size anyhow.
|04-29-2009 09:26 PM|
|AndyLA||Yeah, it depends on the tire...I have seen rubbing on a 33" at stock JK height. It is minor but still there. I wouldn't upgrade wheels and tires w/o doing a Skyjacker, RE, or Teraflex BB lift at least for starters.....|
|04-29-2009 04:49 PM|
|CNTLOSE||From what I was told today at the dealership you can run up to a 33 inch tire with no rub at factory height. Also the rear gate was redesigned on the JK's to hold a 33" spare wheel and tire...so you do not need the swing out arm. They had one in the showroom today with just a 2.5 lift and it was at least 4-5 inches from the fenders.|
|04-29-2009 04:17 PM|
|04-29-2009 04:11 PM|
Lift vs. OEM Rubi wheels
Ok. Finally pulled the trigger on a set of 285/70/17 tires for the OEM Rubicon wheels I have sitting in my garage.
Here are my questions:
1. Will this setup (32.8" diameter) fit on my stock height 2-door X? With/without spacers?
2. Will I need spacers when I add a 3.5" Rock Krawler lift?
Thanks! Mark W.