Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > YJ Jeep Wrangler Forum > YJ Tech Forum > Tools needed?

Join Wrangler Forum Today


Thread: Tools needed? Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
04-26-2013 01:46 AM
95YJkid14 I'm almost done with my semester and at the place I work over the summer they have an impact wrench so might wait till then to try and get them loose!
04-25-2013 06:36 PM
mbannin Rent or buy an impact wrench. I just purchased a '94 YJ and have been doing some work on it. Some of the bolts would not budge without the impact wrench. In fact, it was a little scary how long it took for a couple of them to come loose.
04-25-2013 05:27 PM
nickbdub22 don't bother soaking! I did the same thing and couldn't even budge them with a 3' breaker bar! 1/2" impact, Mine were permanent so I just had to cut them off. Trust me you wont want to put them back on after you feel the difference!
04-24-2013 12:03 AM
95YJkid14 Alright sounds good I'm probably gonna soak them for a few days then try it again!
04-23-2013 11:53 PM
jokerchief462 If they are not going back on cut em off and your done!! Yes on the ground it will have no effect except better handling on and off road.
04-23-2013 11:00 PM
1st87yj Also. PB blaster a few times before trying, and yes no need to jack up the jeep.
04-23-2013 10:58 PM
1st87yj just took mine off. however i did it at work where i have an impact wrench and a torch...on the front i took the nut and bolt off on the axle side. the frame side i left in. i took the axle side and zip tied it to the frame on passenger side. its disconnected, out of the way, and easly reconnectable. just a thought
04-23-2013 10:50 PM
95YJkid14
Tools needed?

I tried to take off my front and rear track bars today and it didn't go very well. I only had a socket wrench and I didn't have the muscle to get the bolts out. Is there any special tools I need to remove them or do I need to go hit the gym a little harder? Also, can I take them off with my jeep sitting on it's own four tires? Let me know!

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 04:32 PM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC