|04-24-2013 12:04 PM|
Unless you have a lift or enough room to sit upright I recommend just pulling it. Keep the trans as level as you can and then jack it up after you remove the t-case. That way you wont loose any fluid.
|04-24-2013 10:25 AM|
|jokerchief462||Yeah check out the Crown video on youtube for a bench install. Doesn't take long the only PIA is the shift linkage.|
|04-24-2013 10:07 AM|
|AV8R||Pull the tcase. It's much easier to do the work on a bench.|
|04-23-2013 09:09 PM|
|04-23-2013 08:54 PM|
|jeepers29||I was wondering the same thing and came across a thread where a member said to back the jeep onto ramps to give yourself more headroom. This is what I am going to try.|
|04-23-2013 08:45 PM|
|YJ360||Just did my SYE. I didn't want to have to pull the case out either thought it would be to much of a pain but in the end I'm happy I did. It's only 6 15mm bolts and you just wiggle the thing right out.. Thinking back to it it would have been a real pain in the a** to try to install the SYE with the case still in the jeep. Before you wiggle the tcase out make sure you disconnect the breather tube and the vacuum lines and obviously the shift linkage.|
|04-23-2013 08:21 PM|
How hard is it to do while in the jeep still? I really don't wanna pull the case but will if need be. Any suggestions?