|04-26-2013 10:54 PM|
|04-26-2013 10:27 PM|
|03Ruth||Or you could buy mine!!|
|04-26-2013 09:37 PM|
|Big Bad Jeep||Never mind on the last question. After doing some hunting around I found a wiring kit I liked. Thanks again on the hitch pointers.|
|04-26-2013 09:02 PM|
|Big Bad Jeep||I do not serious rock crawl, I go mudding more. So clearance is not a big issue. I think I will go with the Draw Tite from quadratec. It is a lot cheaper then Curt. Thanks guys for the info! One more question where is a good place to buy trailer break light kit?|
|04-25-2013 09:02 PM|
The above advice to avoid a bolt on hitch is right on. They bolt on underneath the bumper which leave so little ground clearance in the rear that the hitch will drag incessantly when you are offroading.
If you offroad, you will be MUCH better off replacing your OE bumper with an aftermarket bumper that has an integrated receiver hitch at bumper height.
You can kinda-sorta see what I'm talking about on this very old pic of my previous TJ taken on Sunbonnet in Johnson Valley.
|04-25-2013 08:14 PM|
|04-25-2013 03:39 PM|
I have a Curt (#13408) and it works fine.
CURT Manufacturing - CURT Trailer Hitch #13408 | CURT Manufacturing
|04-25-2013 03:21 PM|
get a bumper w/ integrated hitch and frame tie-ins.
eBay My World - knoblockbumpers
eBay My World - gpfabrication
|04-25-2013 03:16 PM|
|Big Bad Jeep||
What is a good Hitch to buy?
Hey all! I am shopping for a hitch receiver and just wanted some pointers on what is good hitch to buy. I will be towing a 12ft western boat, don't know the exact weight but nothing over the jeeps limit. I have been looking at the Draw Tite Round Tube Max-Frame Receiver. Is this a good hitch? I have a 2000 tj with a four in lift on 33's if that helps.