Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > TJ Jeep Wrangler Forum > TJ Tech Forum > What grounds the starter relay?

Join Wrangler Forum Today


Thread: What grounds the starter relay? Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
04-28-2013 01:11 AM
gsp132 Thanks for the replies!!!

Checked the c-104 connector and it looked real good. Ran ohms check from relay back to the front side of c-104 and it checked good. So I'm loosing it before the connector. I'll do some more checking tomorrow including the connector on the trans.
04-27-2013 03:57 PM
RUBI 4 MY MRS On the manual trans equipped ‘99s there is a jumper at the trans that bypasses the provision for the neutral safety switch for those with an auto trans. It is on the same connector as the back up light switch wires above or on the right side of the trans & switches from brown/blue to black there. If the C-104 connector looks good check that connector for damage. Then there is the possibility that there is a bad wire under the PDC from the relay going to C-104.
04-27-2013 02:54 PM
s14sh3r Here's a pic I took of the connector in another thread.



This is what I found inside:



If you're not getting ground at terminal 86 of the relay, the problem has to be between the ground connector at the right rear of the block and the PDC. I'm all but betting on the connector pictured above. It's the weakest point of the that ground circuit, IMO.
04-27-2013 02:40 PM
s14sh3r It's grounded all the time.

On manual transmissions, it goes from the PDC to connector C104, which is the gray connector near the PCM, if I remember correctly. It ends up grounded to the side of the block on the right rear side. On the diagram I have for a 97, it shows to be a brown/light brown wire coming out of the back of the PDC and connects to a black/wt wire at connector C104. I've personally had corrosion issues that caused electrical problems in that very connector. It was pretty obvious when I disconnected it.
04-27-2013 02:11 PM
gsp132
What grounds the starter relay?

99 4.0 5 speed won't turn over. I'm not getting power to the solenoid. Checked the relay and it's good. I'm getting power to the relay and power to it when clutch is engaged but i have no ground. Is it a common ground and is activated when the clutch is engaged or is it grounded when some other component completes the ground.

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 10:53 PM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC