|05-01-2013 06:46 PM|
|TeraFlex||If you have any more issues, please give us a call. 1-888-837-2359 ext 318 is Doug our t-case expert.|
|05-01-2013 05:38 PM|
|Jaminjer||I finally got this all back together, tried to drive it a few feet and still would not come out of 4 hi. I figured I had put something back together wrong so started taking some things loose and when I tried to pry off one of the linkage arms it moved, jumped in jeep and was able to take out of 4 wheel drive. Found out my linkage had bound up somehow, lubed all the linkage points now good to go. Ordered rear drive shaft so only have one in front, drove to work that way, no problems.|
|04-29-2013 09:12 PM|
|jeepers29||what issues are you having with gear changes? I have not seen anything about issues like that? My shaft and Teraflex kit came today, so wanting to get started tomorrow. Thanks guys.|
|04-29-2013 09:09 AM|
|04-29-2013 12:41 AM|
Good snap ring pliers are a must!!! I tried my wimppy ones originally, finally oreilly had some good ones.
If I were to do it again i think i might pull the whole transfer case. The worst was the oil pickup flange or what ever you call it, making sure it was right. After I had it installed I found a good youtube from advanced adapters Jeep New Process 231- NP231 SYE Install - Slip Yoke Eliminator - YouTube.
I did leave the transfer case in as most have advised.
Jeep is on ramps, will have to take it down tomorrow and see if i can rock it and get it out of gear.
|04-29-2013 12:00 AM|
|jeepers29||Thanks water dog.|
|04-28-2013 11:41 PM|
|04-28-2013 07:56 PM|
|jeepers29||Jaminjer, not to hijack, but I am doing this install on Tuesday. Any tips? I was planning on leaving the trans case in the jeep. What did you do? Thanks|
|04-28-2013 07:04 PM|
|PStov98TJ||It helps to be moving at about 2-3 mph to move into/out of 4lo sometimes.|
|04-28-2013 06:26 PM|
|Herbie424||Usually have to be in neutral to get into or out of 4lo and sometimes even crawling forward babysteps|
|04-28-2013 03:57 PM|
installed SYE wont come out of 4low
I just installed teraflex SYE into my 231 transfer case. I am pretty sure I got it all together correctly. Should I be able to take it out of 4low without starting it?