Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > General Jeep Discussions > General Jeep Discussion > Spiderwebshade and freedom top panels

Join Wrangler Forum Today

Thread: Spiderwebshade and freedom top panels Reply to Thread
Post Icons
You may choose an icon for your message from the following list:

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:


Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.

Additional Options
Miscellaneous Options

Topic Review (Newest First)
04-30-2013 08:49 PM
Boxerdad Well I'm 6'3" tall and with it in place with freedom panels it is to low so....

I took panels off took all the balls except the back two rolled it up and the used mini bungies to hold rolled cover

It will be easy to reinstall next time panels are off

Bed part it does bother my head and my hot head liner is visible which I like!!
04-30-2013 08:35 PM
0II1II0 I take off all 7 of the front spider balls. (three short that connect to the footman's loops and the 4 long on the sides) I let it hang down, put on the freedom tops, then use two long ones and connect to the freedom top latches. It's not tight but it's out of the way enough that it doesn't obstruct my view using the rear view.
04-29-2013 06:13 PM
Originally Posted by Boxerdad View Post
What about the two bungees where the center srew goes in to hold freedoms panels
Not following you. The only spiderballs you need to manipulate are the front left and front right. You take them off to latch the panels. I don't put the two screws in anymore. They are somewhere in the garage.

EDIT: Just saw your other thread. I have the full shade so my comments may be off since you have the JKini.
04-29-2013 06:08 PM
Seginus The only tricky part is getting the center latch covered by the shade. I just rub the latch through the shade; kinda sliding it open or closed. The two other covered latches you can reach up through the gap to open/close. Other than that it is easy peasy.
04-29-2013 06:07 PM
Boxerdad What about the two bungees where the center srew goes in to hold freedoms panels
04-29-2013 04:14 PM
SuperTJ You just have to reach behind it. I had one on my 2010 . I removed the center bungee to latch the middle but that was it.
04-29-2013 04:12 PM
Spiderwebshade and freedom top panels

As I understand it the shade stays on??

I am trying to understand how I will be able to remove and reinstall the freedom panels with the spider shade in place?


Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

All times are GMT -5. The time now is 09:41 PM.

Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC. is not in any way associated with the Chrysler Motors LLC