Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > TJ Jeep Wrangler Forum > TJ General Discussion Forum > Gas tank removal help needed 99 TJ

Join Wrangler Forum Today


Thread: Gas tank removal help needed 99 TJ Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
05-01-2013 08:25 AM
mrobinso I think you should be fine taping it. Not ideal obviously, but it may prove hard to find a replacement.

That locknut is a frickin' bear to get off. Not to mention, once it is actually off it is a PIA to get back on because it doesn't want to line up with the grooves. Cheap PIA design. To get it off, tap the ridges on the locknut portion with a hammer and large prybar. Something that has some weight to it. Be careful obviously, but that should have enough weight to move it after some tapping. I found using a screw driver to tap with a hammer didn't work because it didn't have enough weight and width to turn the lock nut. With regards to getting the locknut back on, that strapwrench will actually come in handy. Just keep at it man. It is just generally a PIA process.
05-01-2013 05:51 AM
ChaddG if you can find a replacement one, I would check the junkyard first, they just press in. super simple.
04-30-2013 05:49 AM
97TJAC yeah really cheap design
so since mine is broken are they easy to fix/replace
04-29-2013 04:21 PM
ChaddG Those red clips break very easily be careful they only come out a little bit.
04-29-2013 02:38 PM
97TJAC when i just did mine I broke the red clip so now the plugs do not stay connected on their own without the help of electrical tape

can these be easily replaced?
12-31-2011 10:16 AM
scoobyjeep If the red clip comes all the way out it wont hurt anything is just a saftey clip so the connector does come disconnected on its own
12-31-2011 08:43 AM
Red Neckerson
Quote:
Originally Posted by davekippen View Post
Does the red clip come all the way out or does it just slide over?
If I remember right it should slide then you gently squeeze them together on it should release. I think just on the 05-06 models the red tab comes completly out.
12-31-2011 08:19 AM
davekippen Does the red clip come all the way out or does it just slide over?
12-31-2011 07:55 AM
scoobyjeep becareful with the fuel pump locking ring, its plastic. dont use a drift and hammmer or what not, if you break it its not real cheap, they do sell a tool for it. GenRight Off Road Part GST-1001 - Fuel Pump Lock Ring Tool not saying you have to buy this tool but might be cheaper than breaking the ring and trying to buy a new one
12-31-2011 07:46 AM
john4ward my bud and i replaced my skid on my 98 earlier this week. the red clip is the whole deal.... we struggled with it too... finally used a very small flat blade screw driver and jimmied at it until a few grains of grit that had become embedded in the clip and the housing. the grit had worked its way into the slide mechanism over 13 years and fused it all pretty tight.... it needed to be worked in a awkward position too. it came apart after a few minutes... but it is a PITA....
12-30-2011 06:31 PM
davekippen I bought one of those strap wrenches and it still wont budge. I hit it with penetrating oil tonight so maybe tomorrow...
12-30-2011 05:17 PM
ygohome for the fuel pump ring you can get a strap wrench for cheap at lowes or sears etc. it is what I used and was an easy removal.

12-30-2011 03:55 PM
Red Neckerson Aluminum Gas Tank Skid - 2

Try this from Stu's site.

I have pulled mine and it can be a pain to get the connectors apart. Be patient or the red tabs could break.
12-30-2011 02:59 PM
WaterDR Look for ones that address skid plate replacement. you have to drop the tank to do that and there are some very detailed videos out there.
12-30-2011 02:47 PM
davekippen I dont see any youtube videos that will help?? Daemon, I thought maybe they had something to do with it but they dont seem to slide. Maybe i wasnt trying hard enough!
12-30-2011 02:19 PM
QADaemon For the connector, the red part is a lock that slides out a bit first. Should be easy after that.
12-30-2011 01:45 PM
WaterDR Go to You Tube. There are some great vids out there for this precise job.
12-30-2011 01:09 PM
davekippen
Gas tank removal help needed 99 TJ

Need to pull out the tank, I have it most of the way out. 99 TJ

1) I cannot figure out how to disconnect the fuel pump wiring clip. Please tell me the secret. I hate electrical connectors. I can never figure them out. (first picture)

2) I cannot get the large flange to loosen up to remove the fuel pump. I read somewhere to hit it with a drift but I have been beating the snot out of it and it wont budge! (Second picture)

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 01:04 AM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC