Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > TJ Jeep Wrangler Forum > TJ General Discussion Forum > Need help

Join Wrangler Forum Today


Thread: Need help Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
05-04-2013 05:09 PM
Glossy422 I would pull the coil pack. Might as well replace the plugs. Then make sure the pak is good and that the connectors on the inside arent messed up. Then check all the cables from the pack. I think they are back toward the cab. There is a little connector back there.
05-03-2013 06:37 PM
Azylkie2809 One the coil pack itself how can some tell the diff from a n b? Also do u guys think it has anything to do with the cam sync?
05-03-2013 05:12 PM
Glossy422 Hey I looked around and found this: http://www.obd-codes.com/p0352. Hope it helps.
05-03-2013 04:40 PM
Azylkie2809 Anyone anything?
05-03-2013 02:51 PM
Azylkie2809 Well it runs now turns out a injection cable rubbed through n caused the fuse to pop... Now I'm getting code p0352
04-30-2013 09:26 PM
03ShaleGreenSahara What diagnosis have you performed so far? Have you checked the ECM for codes? That's the first thing I would check.

I've also seen this scenario happen when the key loses its registration to the computer. The engine will turn over but the ignition won't function. This can be common with non factory keys or if there is only one key registered in memory.
04-30-2013 05:39 PM
Azylkie2809
Need help

Hey guys I have a 04 wrangler with a 4.0. No spark..I replaced the coil and crank shaft sensor still nothing...I hear the fuel pump priming switch the fuel pump n horn relay around...still nada

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 04:00 AM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC