|05-06-2013 10:36 PM|
|05-06-2013 12:05 PM|
|Deep||Thanks all! I figured the door sensor would have been in the door frame somewhere but it makes sense now.|
|05-06-2013 01:10 AM|
I still have not figured out where the door ajar sensor is on these things. these new vehicles use wizardry I swear.
lets not forget it shuts off your radio too!
|05-05-2013 11:28 PM|
|woansleftpeg||And your door ajar sensor is tied into your alarm. Pretty important bit of wire. You have a harness on both sides (and on all four doors if it's a JKU), just reach into the footwell and you'll see a plug - pull the red tab down until it clicks, then press the button in and disconnect the harness.|
|05-05-2013 11:14 PM|
|jkmohican||As said, it's for the dome light and door ajar sign. I just removed my doors today, be sure to not use force while pulling those wires, just pull down that red tab and push on the black tab.|
|05-05-2013 11:08 PM|
|relyt||It triggers the dome light. Thankfully without the wire connected you don't need to pull the dome light fuse like you did on the older Jeeps.|
|05-05-2013 11:06 PM|
Removing Doors - wire
Just got my new Jeep (2013 2dr Sport) and I can't wait to try it without the doors. Took a quick look and noticed what looks like a wire that would need to be unplugged (drivers side - did not check other side). Just curious as to what this wire is for? I have no power locks or anything and I can't figure out what it would be for? Anyone know? Or maybe I'm missing something obvious.