|05-08-2013 12:10 AM|
|Squirrel 442||That should fix it then, and you're welcome|
|05-07-2013 11:14 PM|
|fire66dave||No, it's not loose... Hey thanks for the tip, I'll try it out!|
|05-07-2013 05:12 PM|
Per instructions you grab each corner of the metal frame on top and bend the bar inward (toward the jeep) until you have a good seal.
For comparison, when I pop the latch to open the door from inside my jeep the doors spring open. I have zero leaks and zero flapping.
Just bend it a little at a time until it has a tight seal.
Your door fabric/window isn't loose is it?
|05-07-2013 04:53 PM|
|fire66dave||Yes, just like yours|
|05-07-2013 11:55 AM|
Is the seal good? You need to bend the upper bar frame a little so the door seals against the top.
Edit: are your windows like mine?
|05-07-2013 11:18 AM|
|fire66dave||Maybe I should clarify: it's my door windows, and it flaps on the upper part|
|05-07-2013 08:27 AM|
|Squirrel 442||Here is a pic, I also have a Best Top. You can see the spot were the bar was rubbing the window.|
|05-07-2013 08:20 AM|
|Squirrel 442||I went to Lowes a bought some pipe insulator padding to wrap the rear bars that the windows flap against. No more flapping and it does not look bad. I'll snap a pic, the padding also works good on go kart roll bars|
|05-07-2013 12:40 AM|
Mine flaps only if I did a crappy job putting the top up.
Then with the door windows I sit them in the sun for some time before I wrap them around their frames
|05-07-2013 12:37 AM|
|05-06-2013 11:29 PM|
|AKohler883||Does it flap when completely zipped up ? Mine typically oy does it if I have a side window down and the air goes back and can't get out.|
|05-06-2013 10:50 PM|
|fire66dave||Lol! Absolutely the best remedy...kinda sucks in the rain tho... Or below 55 degrees|
|05-06-2013 10:43 PM|
|Wranglin4Life||Take the top off.|
|05-06-2013 09:25 PM|
I can hardly get the wife to ride in my '92 b/c the windows flap when I get up to 45mph or above, especially when the wind is gusty.. I have a Best top soft top/windows. Has anyone figured out a way to help solve this?