|05-11-2013 02:49 PM|
|05-11-2013 02:48 PM|
|benjamin.allen||Not sure what you are expecting to flex here|
|05-11-2013 02:27 PM|
|MeSteve||Not attached to the shaft, runs from sensor thru wire management, into larger harness, there just isn't any room for flex|
|05-11-2013 02:25 PM|
|COLOUJK||The steering shaft should not be moving there, only rotating.|
|05-11-2013 01:56 PM|
|MeSteve||There is zero play in the wire leading to the upstream O2 sensor so any flex will stress the connection|
|05-11-2013 01:03 PM|
|COLOUJK||So whats the problem?|
|05-11-2013 01:01 PM|
|ljrubitm||I just went out and looked at mine. It's the same way ( 2011). That's just the way it is.|
|05-11-2013 08:28 AM|
Here we go, didn't realize my phone didn't upload either pic.
It's hard to see in the first photo, but it is right above the steering shaft, that is the black shaft in the second photo.
|05-10-2013 11:16 PM|
|ilikeguns||pics or it never happened|
|05-10-2013 08:00 PM|
|MeSteve||Can't get the close up pic to load from my phone...|
|05-10-2013 07:53 PM|
Found this just snooping around under the hood
The wires going to the first O2 sensor were pulled tight thru a wire guide. This is under the steering shaft on the drivers side.