|05-18-2013 09:52 AM|
|fonecop1||Well it actually turned out to be the knob, when I was trying it I could tell it was switching between modes but because it was broke it was not clocked on the right mode. Once I pulled it off with pliers I could see it was broke, of course I didn't go get the pliers and pull it off before ordering the replacement switch. Now for the next thing, the fan only blows on high now, gonna open a new thread for that but wanted to mention it here. I think that may be the fan resistor but will see what others have to say. Thanks for the help guys|
|05-11-2013 09:00 PM|
|fonecop1||That is great info, I'm gonna try to pull it out tomorrow to give it a visual inspection. If it looks good I'm gonna order that from Amazon. Thanks|
|05-11-2013 02:37 PM|
|RUBI 4 MY MRS||
It sounds like you need a new mode switch. You don’t need to get the whole panel, the switch is sold separately. The dealer part may not be available but here is a link to one on Amazon. The mode switch is a 2 part switch. One part directs vacuum to work the actuator doors, the 2nd part is the electrical part that turns the A/C compressor & fan on & off. You apparently have a bad electrical part. Make sure the 3 wire connector on the back is not melted or the terminals are not discolored. If they get too melted the wires can touch each other & give the same problems you describe but that is extreme so more likely the switch is bad. Just be sure to check the wires before ordering the switch.
There is a vacuum reservoir to "store" vacuum so the actuators may move 1 or 2 times after the engine is off. That is normal.
Mode switch part # (?) 05183289AA w/A/C (may not still be available) (?)
Mode switchJeep Wrangler TJ 99-04 Heater/AC Vacuum Switch Mopar
Jeep Wrangler TJ 99-04 Heater/AC Vacuum Switch Mopar : Amazon.com : Automotive
|05-11-2013 10:17 AM|
|fonecop1||It's not the knob. What's strange is even with the key off while checking the knob and changing positions I can hear the blend door changing when I switch positions.|
|05-11-2013 09:28 AM|
|fonecop1||better check that, thx|
|05-11-2013 09:04 AM|
|05-11-2013 08:55 AM|
|debobrute||Did you check the selector knob on the right side and see if it is broken where it slides over the actual control. When I bought my jeep it was broke and doing the same thing.|
|05-11-2013 08:40 AM|
Heater/AC Control Head
I believe mine is bad because the fan will run on all speeds even with the AC/Heat selector in the Off position and the AC compressor is cycling and blowing cold air with it in the off position. Orielly's said they can't get it that it's a dealer part. I looked on Rock Auto and they have an Airtex brand for $82, the dealer told me $136. So the question is should I go with the Rock Auto one, or is there a reason why I should stick with the dealer part on this one?