Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > TJ Jeep Wrangler Forum > TJ General Discussion Forum > Few questions before I HERC my TJ.

Join Wrangler Forum Today


Thread: Few questions before I HERC my TJ. Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
05-18-2013 10:32 PM
wranglerbob1 Thank you for responses. Going to order the rubber plugs. I am not rock crawling just want to cover up the little dings and since I am going to do tub decided to do same time. I looked for pics but cant find any good ones.
05-18-2013 10:17 AM
gbendezu 4 Body Floor Drain Plugs Fit All Jeep Wrangler TJ 1999 Through 2006 | eBay

Replace Steel Drain Plug with Rubber Jeep Wrangler TJ | eBay
05-18-2013 10:14 AM
gbendezu Hmmm I'd try a hardware store like ace or home depot or even a local one and look for grommets similar to the one used for the firewall in the drivers side.
05-17-2013 04:49 PM
wranglerbob1 Don't want to remove them until sure. They may even be clipped. I will have to go look.
1 last question...I just chiseled out the drain plugs in the floor. They were held in with a sealent and metal with two clips on the bottom. Where do I get rubber ones to put in the holes?
Thanks
05-17-2013 04:36 PM
gbendezu I would do a small patch of fiberglass, but these might be hung by just tape not sure. Body puddy or bon do isn't a good idea as it sucks in water even when dry. You'd have to seal it from the back with a primer so that it doesn't suck in any water. Fiberglass is a bit easier plus completely waterproof. You could even go with duct tape from the back hahaha jk!
05-17-2013 04:30 PM
wranglerbob1
Few questions before I HERC my TJ.

Spent last 2 days sanding inside of tub to do the Herculiner bed coat. I was looking at the outside where the rockers are and I have a few little dents there. I was going to get rocker guards down the road but was thinking about doing it the same time as tub with the Herculiner.
Question is when you remove the little trim part ( forget the name) that flows with the fender flares I am thinking there will be a hole or two there in the body. If so what do I fill with before doing the liner? Also I am sure it has been done but I cant find it on here. Anyone do it? Pictures? hold up well?
Thanks

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 09:46 PM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC