|05-19-2013 07:37 PM|
|MGHDTi||Pump in, leak gone Thanks again Wrangler Forum.|
|05-19-2013 04:02 PM|
|MGHDTi||Thanks for the replies, everyone. I'm in the middle of replacing it right now. The seal had deteriorated so badly, it was almost non existent...|
|05-18-2013 09:52 PM|
|PiePuncher||Because of where the fluid is located, check your freeze plugs. They are known to go bad over time. If thats not the case, check both radiator hoses under pressure. It does look like radiator fluid.|
|05-18-2013 08:50 PM|
I just had a similar problem. It is very likely the water pump, based on the coolant showing up just under the main pulley/timing cover----but check all of your hose clamps very closely and while the engine is running and the system is therefore under pressure. Any pinhole hose leak or weeping from the waterpump will show itself.
Also, be very careful about those worm-drive clamps, especially at the pint where the water pump connects to the lower radiator hose. For example, after I replaced my water pump, I was still mysteriously leaking coolant (not from the pump) and found that the worm-drive clamp I used on the lower radiator hose to water pump connection was weeping at the connection/clamp.
Found the clamp was not seating well enough to clamp with enough force to seal the connection. Had to reseat the clamp several times to get it "just right" and also put some silicone sealant on the connection and add another worm drive clamp to seal the connection sufficiently. To be honest, the OEM pressure type clamp did a better job and I regret throwing it away in favor of the worm-drive clamp.
|05-18-2013 07:17 PM|
|Jerry Bransford||When the water pump goes bad, it usually starts leaking from its weep hole on the front. That's almost a sure bet your leak is coming from there.|
|05-18-2013 05:29 PM|
|MGHDTi||Awesome. Well not really, but thanks everyone, based on what I've found online as well as some pictures, it sounds like my pump just went bad. Thank you!|
|05-18-2013 05:09 PM|
|05-18-2013 05:09 PM|
|tangofox007||It's very common for a water pump leak to make it appear that the lower hose is leaking. I would suggest removing the water pump pulley for a better look.|
|05-18-2013 05:06 PM|
|05-18-2013 05:02 PM|
|05-18-2013 03:27 PM|
|MGHDTi||It's not oil, it was the typical bright green all the way around. It's not quite pouring out, but it's definitely leaking at a fast pace, but what I'm confused about is why I'm leaking coolant from the areas in the pictures above... All radiator hoses check out, snug, tight, and they're fairly new.|
|05-18-2013 03:06 PM|
|DIY07||From the pics it looks like oil not coolant. If it is coolant open radiator cap and fill it up start engine and look for leak. If it is pouring out it is more likely a hose or water pump. But could be a hole in radiator. Radiators usually seep rather than pour unless it has been hit by something.|
|05-18-2013 02:58 PM|
Help! Coolant's leaking everywhere...
I woke up this morning, drove to get some coffee, came home and there was coolant pouring out from under the Jeep. I'm not entirely sure what the correct name for it is, but I think it's coming from around the oil pan (?) which doesn't make much sense to me... but I'm hoping it's as simple as getting a new seal and throwing it on.
If there are other threads out there, please direct me to them, I had no idea what to search for. Any help is appreciated!
97 I6 4.0