|05-19-2013 10:04 AM|
Ford or chevy 44 or chevy 10b front and dana70 or chevy 14bolt rear.
If you want it narrower than full width then wagoneer wide track d44 front c&c 14bolt rear.
Dana 60 front would be nice, but not really needed for 35s.
Motor specs? I sure have seen a lot of "400" hp small blocks that felt like a 300hp small block.
|05-19-2013 09:32 AM|
|Nubby55||oh and it should do nice wheel stands!|
|05-19-2013 09:31 AM|
No like a Dana 60 in the front and a Dana 70 or 80 in the rear with 400hp to the ground and running 35 ins. of rubber!
|05-19-2013 09:28 AM|
|wrangleryj90||If you can put the engine in you will have no problems with an axle|
|05-19-2013 07:58 AM|
|bigboystoys||Like a Chevy 12 bolt or Ford 8.8 with 4.10 gears? Is it relatively easy to install axles?|
|05-19-2013 07:45 AM|
|Norcal_Chris||Not at all. I would reccomend at least 3/4 ton axles.|
|05-19-2013 07:10 AM|
will stock axles hold up?
Just recently bought a SBC 406 to put in my jeep. Has about 400 hp. I am running stock axles with 35's. Will the axles hold up running that much horsepower and tire? If not, what would be a good way to beef up the axles I have?