Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > TJ Jeep Wrangler Forum > TJ Tech Forum > need tips on rear flare removal

Join Wrangler Forum Today


Thread: need tips on rear flare removal Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
05-20-2013 06:01 PM
Usnrubi143 big Rock or a tree just rip that SOB off haha
05-20-2013 04:37 PM
XwXCHADWICKYXwX I don't have any plyers so I took vice scripts and clamped em down on the screw and wiggled it out. May not have been the best way to do it but what's done is done
05-20-2013 04:20 PM
Jeffreybomb I removed my fender flares from my Jeep to paint them. I didn't want to mess with the wheel well insert because I didn't think the plastic push pins holding them in would come out in one piece. My TJ spent a lot of time in the southwest with its PO so some of the plastic lost its pliability.

I bought a set of long needle nose pliers similar to this and poked it up between the panel and the wheel well insert. I "felt" around with the tip when it was up in there and was able to grab each nut while I spun the bolt. Getting the nuts out was easy enough, but putting them back in took some patience.
05-20-2013 04:09 PM
JimsJeep You probably have a nutsert spinning on you and most likely you will have to remove the fender liner to get to the back.
05-20-2013 04:00 PM
XwXCHADWICKYXwX
need tips on rear flare removal

I'm in the process of putting on my new genright rock sliders and have to take off only the first screw on the flares to slide the rockers under them then drill the holes required to put them on. I got the driver side front and passenger rear one off but the other two just spin and don't move. There is what seems to be a nut on the inside of the front passenger that I'm working on but don't know what to do for the driver side rear. Any ideas on how to get them out?

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 12:32 AM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC