Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > TJ Jeep Wrangler Forum > TJ General Discussion Forum > What do I need for 32"s

Join Wrangler Forum Today


Thread: What do I need for 32"s Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
05-31-2013 05:31 AM
tallzdatank when i got my tj it was on 32s. while off roaring once I rolled one off the bead and damaged the sidewall trying to fix it on the trail. when i tried to replace it, the one 32" tire was going to cost me almost $300. where a whole set of 5 31x10.50s cost me a $550. it could just be that it was an uncommon size around here and nobody stocked it. but I would recommend just doing 31s. since swapping ive noticed very little decrease in clearance if any, and my 2.5 feels a little better on the highway.
05-30-2013 10:00 PM
obiefox For just 32's and light off roading, I would just stick with a 1 inch body lift.

Hell, just put the 32s on and figure it out later. Exactly which "32's" are you looking at?
05-30-2013 08:56 PM
spenserb appreciate the response jerry
05-30-2013 11:02 AM
Jerry Bransford To run 32x11.50 tires, you only need aftermarket wheels with less backspacing & a 1" to 2" suspension lift or 1" body lift.

The factory wheels have too much backspacing (5.25" to 5.5") which means they position a tire that is wider than 10.5" so close to the springs in the rear that the inside sidewall could rub on the spring perch. Nearly any aftermarket wheel will have less backspacing which would allow a 32x11.50 tire to be mounted. Wheels with 3.75" to 4.5" of backspacing (which is not the same as 'offset') will do it.

With a 2" suspension lift, you may or may not need a small amount of t-case skidplate drop. 1/2" or 5/8" worth of spacers between the frame & t-case skidplate should be enough to eliminate any vibes a 2" suspension lift might (or might not) cause.
05-30-2013 10:57 AM
spenserb Like do i need a tc drop? i see stuff about trac bar adjustments? control arms? I rely on my jeep alot just dont want problems.
05-30-2013 09:59 AM
spenserb
What do I need for 32"s

I want to get some OME coils and probably some Rancho 9000s shocks. Ive been reading about custom lifts on here. What else is needed. This is my DD. Light offroading mainly just driving to the deer stand. thanks

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 10:01 PM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC