|06-02-2009 03:10 PM|
|06-02-2009 03:00 PM|
|06-02-2009 02:56 PM|
|jerryj||I took that into concideration and decided im trying to cut down on my bug intake ,cant think of why youd want it down some might i guess.|
|06-02-2009 02:30 PM|
|4point||If you ever wanted to drop your wind shield it'd be in the way.|
|06-02-2009 02:20 PM|
i use a 54 inch smittybilt trail jackneo
|06-02-2009 01:00 PM|
Mine swings out on the tire carrier.
|06-02-2009 12:47 PM|
Fourtreks aluminum highlift mounts.
|06-02-2009 01:28 AM|
Couple of aluminum fence post clamps, two bolts, few washers, and some wing nuts from ACE hardware....total was something like $2.86.
You can mount it higher or lower on the roll bar as you like.
I no longer have it there but it works. My resides in the garage or mounted to the box I have built into the back of my tub.
|06-01-2009 11:00 PM|
|Bigstonz||2nd post of this pic today.|
|06-01-2009 10:35 PM|
|Ironman||I designed and fabed a bracket that holds my Highlift up below my spare tire. It plugs into my receiver hitch.|
|06-01-2009 06:39 PM|
|jerryj||I put mine on the hood,I like it best there.I had it vertically mounted on the back and it was always in the way.|
|06-01-2009 06:07 PM|
|Jerry Bransford||About the best easy/cheap way to mount a Hi-Lift is at the base of the rollbar at the rear. Just get some big u-bolts like you might use for chain-link fence posts and secure it to the rollbar using wing nuts and washers. That's a real popular location. Just don't mount it to the radiator support rods inside the engine compartment where it just gets too hot to touch in addition to other problems that location causes.|
|06-01-2009 05:37 PM|
HI LIFT Mounting ideas..?
Hey guys haven't been on here in a while, but I've been real busy doing repairs and upgrades. All that is left is the fun stuff....i bought a hi lift and was looking for mounting ideas, any suggestions or pics would be great, thanks.
Recent upgrades....6 speaker sound bar (camo), roll bars pads(camo), kicker sub woof in the truck (can't get to fire, diff. thread), BAnks monster cat back exhaust; 1" BB (this ended being about a 30 hr project, as body mounts were all rotted and not even holding the body down, gutted the whole interior, cut and replaced all rotted sheet metal with thicker gauge sections); and new tuffy center console and glove box... yet to be installed are tube nerf bars and the hi lift set up, I'll try to post pics!