|06-13-2013 09:16 PM|
|03 sahara jeeper||I would look into the rust on the rear lower control arm mounts. Check the frame for rust especially around the transfer case skid plate. Make sure 4 high and low work. Check the heat and AC in all positions. Looks pretty clean.|
|06-07-2013 10:45 AM|
|Verf||Thanks a lot for all the help, I really appreciate it!|
|06-07-2013 09:58 AM|
How to Calculate a Rear Differential Gear Ratio - YouTube
there should be a plate if I'm not mistaken on the diff cover - but the dealer should know this or be able to determine it.
I'd check all of the frame - bring a screw driver and poke around - but specifically the rear by the coils. I think that's common - but the TJ forum guys probably know more.
You might find these articles helpful, too:
Jeep Wrangler TJ Buyers Guide - Jp Magazine
Ten Jeep Wrangler TJ Problems - Jp Magazine
|06-07-2013 08:06 AM|
|Verf||Thanks! How do I confirm the gear ratio? With the VIN? What specifically should I look for on/in the rear frame?|
|06-07-2013 07:15 AM|
|NHflannelman12JK76CJ5||confirm the gear ratio - 4.0 stick should either have 3.07, 3.73 (my bet) or the 4.11. Depending on what you want to do with it, you may not want the 3.07. That's a pretty decent price. The folks in the TJ forum should know more. But since this is a NH rig, I'd check for rust on the frame - in the rear. This one looks clean and I've seen it driving down route 9 from the road but I haven't stopped in to look at it (i frequent Keene).|
|06-06-2013 07:23 PM|
Possible purchase, thoughts?
Been in contact with the dealer and will drive up to see it Sunday. I'm new to Jeeps and looking for thoughts on this one and what I should look for when inspecting it.
2005 Jeep Wrangler Unlimited - Mazda dealer in Keene New Hampshire