Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > TJ Jeep Wrangler Forum > TJ Tech Forum > changing ball joints on my dana 30 on 1999 tj wrangler

Join Wrangler Forum Today


Thread: changing ball joints on my dana 30 on 1999 tj wrangler Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
06-07-2009 12:33 PM
snwchris here's the link from previous dicussion and a couple write-ups. Hope this helps
http://www.wranglerforum.com/f5/ball...nts-29520.html
06-07-2009 12:35 AM
1BLKJP Put the new ball joints in the freezer for a few days until you are ready to do the job. If you have access to a blue wrench "cutting torch" use it to heat up the knuckle til it's glowing red. Then grab the ball joint out of the freezer and drop it in. Might still have to use the press a bit but it will make everything much easier.

The axle nut on the TJ's are 36mm. The brake caliper bolts are 13mm and the unit bearing bolts are 13mm 12 points. Lower ball joint nut is 1 1/8th and I believe the upper is 26mm.
06-06-2009 04:16 PM
neo
changing ball joints on my dana 30 on 1999 tj wrangler

i just bought 4 new ball joints and picked up a ball joint press at auto zone.
i am spraying everything down with pb blaster the next few days,i have changed ball joints out on A arm equiped 4 x4's.what is the spindle nut size,does any one have any pictures or useful info on changing ball joints,i have done all kinds of work on my jeeps for years,body lifts,suspension lifts
wheel bearings,brakes,u joints,clutch's changes,engine changes,i just never done ball joints yetneo

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 07:33 PM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC