|10-16-2013 12:10 AM|
By the way thanks for sending the adapter for the whistle
|10-15-2013 11:38 PM|
The connectors Rigid Industries provides are high quality units but I think many will find them either too bulky for a clean install or in the wrong place.
The simple answer is often to cut them off and use connectors to tie the light wires to the longer wires needed.
|07-11-2013 10:38 PM|
|RigidIndustries||If you guys have any problems installing our Lights and or bracket setups please feel free to call us and we will help you out with any questions or concerns. Thanks for supporting Rigid Industries!!!|
|07-03-2013 07:05 PM|
|AGGIE_Rubicon||I cut my plug off and extended the wire where I pushed the cable into the channel between the window and the a piller and then run it under the corner and cowl to the battery. I used a black silicone to seal the cable into the channel along the window just use your finger and make it really smooth so that it looks like the window seal. I tried running it between the bracket and a pillar but I couldn't get the holes to line up with the extra thickness.|
|06-24-2013 12:35 PM|
|NFRs2000NYC||Run it behind the PSC mount. I ran mine between the Jeep and the mount, and you can't tell anything is there. No need to drill into the jeep either.|
|06-21-2013 03:06 PM|
|06-21-2013 03:05 PM|
|06-21-2013 01:33 PM|
|06-12-2013 08:45 AM|
|06-12-2013 08:42 AM|
|nwapache||I run mine down the windshield into into the engine bay. You can tuck the connector up top at the bracket and zip tie it, or cut and splice like I did. It's not like you're going to unplug it, or anything|
|06-12-2013 07:47 AM|
|Toolin Around||I would coil the wire up at the top and hide the connector at the top and run the wire down the bracket. Or you can take apart the light and extend the wire so the connector will be farther away and concealed in the cowl.|
|06-12-2013 12:06 AM|
|06-08-2013 04:09 PM|
|justin-branam||Why dont you just run the wire underneath the bracket and then down into the winshield wiper motor area, and then into the engine bay. Almost like you are hooking up a set of windsheild lights. I dont think it will hurt the wire to squish it between the bracket and the outisde pillar.|
|06-08-2013 01:11 PM|
|lemitone||unfortunately NOT... and I didnīt find better ideas here either|
|06-08-2013 11:25 AM|
|05-19-2013 08:08 PM|
50" Rigid LED Light bar wiring
Jeep JK Upper Windshield Mount Kit for 50" E/SR Series Light Bar
am interested in these install
Q: how can that be wired?
A from rigidindustries: the wire can be passed through the upper windshield at the top between the roof seal and then down the inside of the A pillar.
that will leak like hell!
how can it be done propper??