|08-01-2014 06:57 PM|
|Bent jeep||I think that pulling the flares off or getting smaller ones makes it look wider.|
|08-01-2014 06:54 PM|
|Rtp04||Also 15 trackers|
|08-01-2014 06:25 PM|
|11-24-2013 07:51 PM|
These were taken right before and right after the tires got swapped. the same day, within hours of each other...
all the good ones I've uploaded to flickr to post in various threads here and there
|11-23-2013 01:49 PM|
|HollisBT||Whoah, glad I found this thread, gives me some good hope! Also, I'm very glad to hear that some guys have had very positive experiences running 35"s with no lift on the 3.73 gears. I think that will be the route I eventually go, at least until the itch to get 37"s and some lift sets in hehe.|
|11-23-2013 12:06 PM|
|dklassen||I have 2.5 lift but 15's and 33's give it a nice fatty look.|
|11-23-2013 11:06 AM|
Do you have any other pictures of this wrangler?
|09-20-2013 12:00 PM|
|TomAmes55||Low fat look go with 5" backspace 0 offset I run 33x12.5 17 M/T Bajas onmy 2013 Sahara no lift and no rubbing issues at all|
|09-20-2013 03:58 AM|
You want stout? 35/1250/15's with no lift. Mall crawler only.
Then after a 1 inch spring lift and a 1.75 inch puck spacer.
Shes mean. I rip off a lot of fenders though. I buy the clips in bulk.
|09-19-2013 07:46 PM|
|myrtlebeachjeep||I have 33-12.5-17 on mine. Trimmed front air dam|
|09-19-2013 07:37 PM|
|Gunner||35-1250-17 KM2's on MB Black Razors with 4 inch offset. Trimmed the front air dam and the rear of the rock rail. No more noise on the street. 3.73 gears.|
|09-19-2013 06:48 PM|
Nitto Terra Grapplers, 325/60R18 on 18" Eagle Alloys with no lift. Not my first choice on tire or wheel or size but I bought the Jeep with them already on it. I get slight rubbing on the anti-sway bars if I try to go to the limit on steering.
|09-19-2013 01:39 PM|
|09-19-2013 12:21 AM|
|Inmate3030||Another shot from behind|
|09-19-2013 12:20 AM|
|Inmate3030||XD Monster wheels, -12 offset with Hankook Dynapro MT tires|
|09-18-2013 10:41 PM|
|JetRidin||love the wheels too!|
|09-18-2013 10:26 PM|
|JetRidin||What brand tires are those? Looks great!!|
|09-18-2013 10:13 PM|
|Inmate3030||I went with 325-60-18's on aftermarket 18 inch wheels. It is really wide and I didn't have to do any lift. I had to trim the plastic tab on the inside of the bumper by about 1/4 inch.|
|06-12-2013 09:28 AM|
|06-12-2013 09:19 AM|
I ended up with Nitto Trail Grapplers 285/65/18 on Fuel Hostage Wheels, no lift.
|06-12-2013 07:58 AM|
|06-12-2013 06:36 AM|
Oh and, here's a pic after adding RC 1.5" spacers... stock rims, 265/70/17's ... 33's in a couple weeks...
|06-12-2013 06:23 AM|
Side pic? Did you get a lift? If so, pics?
|06-12-2013 01:20 AM|
|06-11-2013 11:10 PM|
|OntarioBlair||I Have Now Added Spacers And Leveling Kit, And Winch And Bumper. Love My Sahara.|
|06-11-2013 12:09 AM|
|06-10-2013 11:07 PM|
Here was mine. I rocked that look with 33's before I did the lift, bumpers, etc.
|06-10-2013 02:21 PM|
The grill guard is chainmaille i knitted out of aluminum rings. Made a chainmaille seat cover, and am smack in the middle of thatching a cargo net out of paracord on a pneumatically lifting steel frame I made
Come to think of it, I suppose I oughtta create a few threads... Been kinda busy on mods for a few weeks
|06-10-2013 01:51 PM|
|06-10-2013 12:09 PM|
Had the fenders stock for a while, but eventually those 33's busted the clips.
|This thread has more than 30 replies. Click here to review the whole thread.|