|06-17-2013 06:28 AM|
|nealwiley||Spot mirror trick????|
|06-15-2013 11:32 PM|
|whitesport||Have an 07 and have taken my hard top on and off countless times and never had a leak. I drive around all Summer with a tonneau, windjammer and bikini.|
|06-15-2013 03:21 PM|
|axhoaxho||If I don't plan to take-off my freedom panels much -- is it better to leave them on, or periodically remove them to grease the seals? Which way would be better to preserving the seals for waterproofing in long term?|
|06-15-2013 12:01 PM|
|06-15-2013 11:48 AM|
The first time we removed the Freedom Tops I had read things on here about not tightening the screws down too much when reinstalling. I loosened the first screw about 1/2 turn and then tightened it again to get an idea of how tight it had been. That thing from the factory seemed quite tight and I would almost have had to use a tool to turn it any further.
Anyway, we've always screwed them back in fairly snug and the tops do not leak.
|06-13-2013 01:48 PM|
I had some minor drips from the front seal on the occasions when I washed it shortly after screwing these in in a gorilla-finger-tight manner. But, there were no drips in the same circumstance if I just screwed them in with a couple inch-pounds of torque (just "light-touch" tight). It's apparent to me that if I torque the big screws down too much it causes some front seal separation or reduced contact-sealing that isn't readily seen.
|06-13-2013 01:30 PM|
Works fairly well. A few pointers:
Secure your rear glass...I used some duck tape.
Put some painters tape on your Jeep just below the pillars in the rear. The dolly kind of clips onto the bottom of the pillar. There's padding inside the clip to protect your roof but what's to protect your Jeep when it slips while you are lining it up?
It comes w a single strap. I added some bungee backups.
Choose wisely where to store it. Initially I had it on the deck of my condo. I had done the measurements...no problem. Until I realized that the dolly added to the height, which made it too tall for the doorway, so me and my buddy had to tilt it. Lets just say I'm going to have some touching up to do when my hard top goes back on in the fall.
|06-13-2013 01:12 PM|
|k2epm||Have any of you bought either the Mopar or Bestop HOSS dolly for the top when it's off?|
|06-13-2013 10:03 AM|
|Qdogfox||Our entire top has been off once...just to do it...and the freedom panels out many times. No leaks that I have seen. The big screws have been out for a while too...still no leaks. I was a little nervous on a 600mi roundtrip freeway trip w/o them, but it was fine. Just go for it, it's built to handle some exposure to the elements anyway.|
|06-13-2013 09:37 AM|
Both my wife and I take our freedom panels off and reinstall without the big screws. Neither of us have had leaks. We go through automatic car washes as well.
If you get leaks just get some clear silicone grease and grease all of the seals. I plan to just as preventative maintenance.
|06-13-2013 08:58 AM|
|06-13-2013 07:11 AM|
I didn't realize hardtop leaks were even a problem. I have had my panels and the hard top on and off many times and don't recall ever having any leaks.
My soft top (supertop NX) will leak in a heavy rain; but the hard top always seals up tight.
|06-13-2013 06:23 AM|
every time I take mine off I have all kinds of leaks
not a single leak when it is back on!
|06-12-2013 09:31 PM|
|GreyGhost||I have a 2012 and have taken the top off multiple times. During the summer I run without the big screws so I can pull the freedom top off fast after work. No leaking yet. It is also great to run with the freedom top on and the top off. Enjoy being topless!|
|06-12-2013 09:21 PM|
|Justanothermoparman||I don't want to jinx myself but, no leaks on my '12.|
|06-12-2013 07:37 PM|
|David-T-71||My Freedom panels come out all the time and I have had the hardtop off only once so far. I have left the panel screws out for weeks at at time and so far no leaks and we have had some torrential rains the last few days.|
|06-11-2013 10:29 AM|
|06-09-2013 10:13 PM|
I experienced a leak after reinstalling my panels a few times but it seemed random. Sometimes it would, sometimes it wouldn't. The location of the leak was always the same though, at the very front near the windshield, right in the middle where the two panels meet. Very annoying as the water would spill right onto my radio. I have recently started something new. I install the panels in the same order like you have to, passenger first then driver side. But I latch the drivers side panel down first, and then latch the passenger side down.
Hasn't leaked since! Luck? Maybe, but for now I'm chalking it up to creative genius lol.
|06-09-2013 10:00 PM|
My CG JKU is the first Wrangler I've owned with a hard top. I removed the freedom panels today for the first time. Wow, what a nice alternative. Not quite topless, but better than a sunroof.
Panels went right back in place. I don't anticipate any leaks.
|06-09-2013 07:17 PM|
|06-09-2013 04:57 PM|
Does anyone else just leave the big screws out?
|06-09-2013 04:41 PM|
After we reinstalled it there haven't been any leaks, although we've had some major thunderstorms since then.
|06-09-2013 02:10 PM|
|06-09-2013 12:10 PM|
|nealwiley||Thanks, its coming off!|
|06-09-2013 10:58 AM|
The first time I took mine off of my 2013 JKR I didn't tighten down the huge screw on the drivers side that connects the freedom panels with the rear top. It was snug but not as tight as I could make it.. We had heavy rains that night and the next morning there was a very very little bit om leakage (maybe an ounce of water if that) but I realized it was because I didn't tighten them as far as I could. Since then I have taken them on and off several times and been through heavy rains with no leakage....
Part of the awesomeness of having a jeep is to take your top off.... just do it and don't look back
|06-09-2013 10:30 AM|
|06-09-2013 10:10 AM|
|st1264||Same with me. Off and on, no problems. Just put the freedom panels on and line them up properly. There should not be any problems at all unless you have bad weather stripping or it's not put on properly.|
|06-09-2013 10:10 AM|
|jkjeeper06||Removing the top won't contribute to leaks. If it leaks, it leaks but it won't be due to taking the top on and off. It's too much fun not to take the top off. Just wet the seals with lithium grease every few months and that will help with leaks|
|06-09-2013 09:59 AM|
|06-09-2013 08:51 AM|
|This thread has more than 30 replies. Click here to review the whole thread.|