Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > General Jeep Discussions > General Jeep Discussion > Lockers

Join Wrangler Forum Today


Thread: Lockers Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
06-17-2013 09:47 PM
madskider
i have a personal vendetta against non-selectables after this... 37 in a 35 around a wet corner, professionally installed detroit... my own fault for not having any weight in the bed, but still... and i had a few close calls with a budy's chevy 2500 once or twice (detroit), and a lincon-locked bronco (front and rear) which is basically just a homemade spool...
06-16-2013 09:14 PM
4Jeepn
Quote:
Originally Posted by madskider View Post
my experience is that, if your going to do only one locker in any vehicle, its best to have a selectable, like an air locker, in the rear rather than the front, and only really lock it when you actually need it... if you have a non-selectable, like a detroit or even worse, a spool locker, in a vehicle that gets used on the road, A- cornering will be... interesting... and B- it can lead to premature axle failure on anything. some, like the D35, will just show the wear a hell of a lot faster than say, a D44 or something else heavier/better designed. as for the front, a selectable is always best, because a non-selectable will puke a Ujoint every time you turn on pavement unless you have manual wheel hubs... in my opinion, i would never use a non-selectable in anything that sees any pavement, although it does get done quite often...
Lots of stuff above that just is not correct. While running a full time locker in the rear it can give some pulling or pushing, however the world will not end, and the sky will come out the next day. This is based on me running the following lockers, ARB, aussie, lock right, Detroit on several different jeeps, so I know how they act. For the front, a non selectable locker will not blow a u-joint when turning on pavement in 2wd. Infact other than some light clicking sounds you usually don't know its in there. Now if you put it in 4wd on pavement..which you shouldn't do even with an open diff.. it will bind very fast. Thus to review..nothing wrong with running full time lockers front or rear on pavement. I will say that for a front full time locker if you get snow in your area, it can make it very hard to steer as the locker wants to fight for traction and steer at the same time.. thus a selectable is a good choice for the front.. out side of that.. not needed.
06-16-2013 08:57 PM
madskider my experience is that, if your going to do only one locker in any vehicle, its best to have a selectable, like an air locker, in the rear rather than the front, and only really lock it when you actually need it... if you have a non-selectable, like a detroit or even worse, a spool locker, in a vehicle that gets used on the road, A- cornering will be... interesting... and B- it can lead to premature axle failure on anything. some, like the D35, will just show the wear a hell of a lot faster than say, a D44 or something else heavier/better designed. as for the front, a selectable is always best, because a non-selectable will puke a Ujoint every time you turn on pavement unless you have manual wheel hubs... in my opinion, i would never use a non-selectable in anything that sees any pavement, although it does get done quite often...
06-16-2013 07:59 PM
4Jeepn dana 35 is a weak axle.. and when locked in stock form it tends to place way to much stress on the shafts then snaps the axle shaft.. which then slides out of the axle tube...
06-16-2013 07:54 PM
TylerU
Quote:
Originally Posted by RubiconRich View Post
Do you have a YJ,TJ I would not put a locker in a Dana 35

If you have a TJ,JK with a Dana 44 I would put a locker in the rear.
why? trying to learn
06-16-2013 07:23 PM
RubiconRich Do you have a YJ,TJ I would not put a locker in a Dana 35

If you have a TJ,JK with a Dana 44 I would put a locker in the rear.
06-15-2013 10:08 AM
D_ninja Ttt.
06-15-2013 09:30 AM
Jeeptj42694
Lockers

What would be better to get front or rear lockers

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 03:56 AM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC