|11-09-2013 10:46 PM|
A-Pillar Gauge Pod for JK 2012
You can get one through Quadratec. Auto Meter 15221 - Auto Meter A Pillar Gauge Pod for 07-13 Jeep® Wrangler & Wrangler Unlimited JK - Quadratec
See my prior post to see picture. They only have one color and it's black.
|11-06-2013 11:29 PM|
|tlminh||so which guage pod will fit the 2012 jk a-pillar? I haven't been able to find any pics of fitment/color|
|10-07-2013 03:28 PM|
.... also got to thinking,
Once some one installs the Apiller gauges,
How does one fold the windshield?
|10-07-2013 03:27 PM|
What all parameters will the Interceptor read correclty on the JKs? I only have Interceptors on my Car (Not a Jeep, but a real car)
|10-07-2013 03:26 PM|
Not on the Jeep yet. I think I may just go Single on the Jeep,
I have had a dual setup on my Car (Chevy Cobalt) four a couple of years and LOVE them!
|10-07-2013 11:31 AM|
|10-04-2013 04:30 AM|
|10-03-2013 02:50 PM|
In case anyone is still thinking about this, Aeroforce updated for the 2013 to also include transmission support, axle ratio, TPMS, transfer case ratio adjustment.
Also, has anyone made a gauge pod that would fit on the center section of the 12-13 Wrangler?
|08-07-2013 12:01 AM|
|jonboy||I bought the Auto Meter one, and mounted dual Interceptors in it. If you order dual gauges they send you the right cable to use to allow them both to read actively at the same time. go for it, I love mine.|
|08-06-2013 11:56 PM|
|07-01-2013 06:58 PM|
Finally ordered mine. Now to figure out which two gauges I want in there.
Most likely a voltmeter and a stoichiometric gauge. Off to see what Autometer has in 2 1/16th gauges.
|06-25-2013 04:30 PM|
|jonboy||How hard would it be to install the sensor in the transmission? Is there an easy place to install it? I may go for this if its an easy install, I'm tired of waiting for Aeroforce to update their gauges for this.|
|06-21-2013 09:23 AM|
|insylem||THey can if you get the sensor kit. Interceptor has 2 Analog inputs. Mount a temp sensor in the tranny, and instant Tranny temp.|
|06-21-2013 03:00 AM|
Funny, I just spent the past 2 hours looking at gauges and mounts for my 2012 JK.
I found the one on quadratec but didn't like the fact I couldn't find descriptions anywhere on the size of the hole but based on the prior post it sounds like you'd need to do a little work to make it fit the aeroforce.
I also found this one, but damn its expensive and frankly I don't like the carbon fiber look.
I ended up putting off my order for now, because the aeroforce gauges aren't yet able to read temperature in the 2012 tranny. I'll be waiting until that gets sorted out before I buy.
|06-21-2013 02:11 AM|
Is that the same as this one?
Auto Meter 15221 - Auto Meter A Pillar Gauge Pod for 07-13 Jeep® Wrangler & Wrangler Unlimited JK - Quadratec
I'm looking into installing a Interceptor set up. If it's a dual pod,
I can go dual interceptors.
|05-27-2013 09:15 PM|
A - Pillar Gauge Pod for JK 2012 -2013
Autometer just released their A - Pillar gauge pod for the JK 2012 - 2013. After waiting 2 months it finally arrived last week. The plastic is much thinner and harder than stock. The color and texture is not the same as the 2013. Installation is easy but you need to be careful with the sharp edges as it can scratch your dash. The gauge opening was smaller than 2 1/16". I had to run a sand drum from a dremel to bore out the opening...
A - Pillar Gauge Pod - Autometer A - Pillar Guage Pod for JK 2012 -2013 Wrangler Forum Gallery
|07-22-2012 12:09 PM|
|Dmactampa||Is there a reason the 07-10 wouldn't work? Seems like a lot of other parts do but I know the contour of the dash may affect it...|
|07-22-2012 04:51 AM|
I take it that I'm pretty well SOL on this idea, but I figured I'd give this one more bump just in case.
|07-15-2012 06:12 PM|
|Metonymy||Bump. Any suggestions?|
|07-11-2012 01:18 PM|
A-Pillar Gauge Pod for 2012
I've seen one for the 97-02, 03-06, and the 07-10 models, but is there one available for the 2012 Jeeps?
I'd love to get one so I can install an air/fuel gauge as well as a voltmeter.
Unfortunately the searches I've done thus far (both on the 'net and on this site) haven't yielded anything.