|07-02-2013 11:37 AM|
|bbtj||I can't answer that one. I have a JK, which has a plastic piece on the inside, which just pops off.|
|07-02-2013 04:53 AM|
|NoBoat0429||The grommet is all fine and dandy but how do you get the wire in the doir in the first place. I have a tj btw|
|06-24-2013 07:59 AM|
|bbtj||No problem, glad to help.|
|06-23-2013 10:37 PM|
Thanks for the tip
I did use that grommet and it almost self-seals itself and is a very clean look. Thanks for the tip bbtj!
|06-22-2013 10:44 AM|
|bbtj||I ran mine through the grommet on the other side, that way I don't have 2 lines running through the same grommet. I then sealed around the cut, didn't see any reason to seal around the grommet itself.|
|06-22-2013 05:52 AM|
Anyone reseal that grommet?
Should have titled it that way, but has anyone routed the coax through the 3rd brake light grommet and resealed it? Thanks!
|06-21-2013 07:16 AM|
Antenna mount from Quadratec
I am installing the tire carrier mount from Quadratec and was wondering if anyone else has used this mount.
It says to route the coax through the tailgate grommet where the third brake light wiring runs.
Do you cut the grommet so the coax can run along side the third brake light, then apply silicone or similar to seal the cut portion of the grommet and maybe even a bead around the grommet?