Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > General Tech Forums > Communications and Electronics > Antenna mount from Quadratec

Join Wrangler Forum Today


Thread: Antenna mount from Quadratec Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
07-02-2013 11:37 AM
bbtj I can't answer that one. I have a JK, which has a plastic piece on the inside, which just pops off.
07-02-2013 04:53 AM
NoBoat0429 The grommet is all fine and dandy but how do you get the wire in the doir in the first place. I have a tj btw
06-24-2013 07:59 AM
bbtj No problem, glad to help.
06-23-2013 10:37 PM
85CJ
Thanks for the tip

I did use that grommet and it almost self-seals itself and is a very clean look. Thanks for the tip bbtj!
06-22-2013 10:44 AM
bbtj I ran mine through the grommet on the other side, that way I don't have 2 lines running through the same grommet. I then sealed around the cut, didn't see any reason to seal around the grommet itself.
06-22-2013 05:52 AM
85CJ
Anyone reseal that grommet?

Should have titled it that way, but has anyone routed the coax through the 3rd brake light grommet and resealed it? Thanks!
06-21-2013 07:16 AM
85CJ
Antenna mount from Quadratec

I am installing the tire carrier mount from Quadratec and was wondering if anyone else has used this mount.

It says to route the coax through the tailgate grommet where the third brake light wiring runs.

Do you cut the grommet so the coax can run along side the third brake light, then apply silicone or similar to seal the cut portion of the grommet and maybe even a bead around the grommet?

Thanks!

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 01:27 PM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC