Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > YJ Jeep Wrangler Forum > YJ Tech Forum > rust under roll bar mount?

Join Wrangler Forum Today


Thread: rust under roll bar mount? Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
06-25-2013 09:26 AM
89Saharagreen
rust

thanks I was thinking 1/8 was a little on the thick side.

I ordered the rear floor repair pans from C2C should be here in a few days.

Hopefully i can use them to repair the rust damage it is really not that bad except for the one driver side. and was thinking of using some sort of roll on bed liner on the underside to prevent future rust.
06-24-2013 02:50 PM
sevenservices ^ that makes sense for sure.

Also, when your all done be sure to paint the steel/bolts/nuts undernieth so they don't start rusting again on ya from the underside.
06-24-2013 01:23 PM
0III0forlife If I were doing it, 1/8" would be plenty. Actually the steel that I use for body panel replacement is 16 GA. It is about twice as thick as standard body tin.

Cut out the bad parts and replace with your choice of steel, the thicker that you decide to use, the harder it will be to weld without burning thru on the original steel.

When I did mine, I re-drilled for the roll bar bolts, and made a plate that fit under the body to "sandwich" the repaired section and give it more support. The vertical part on mine was good and solid, so it made it easy to re-align the roll bar.
06-24-2013 12:29 PM
89Saharagreen
rust under roll bar mount?

Ok everyone took the roll bar out to get ready to monstaliner the tub instead of carpet.

Found horrible rust completely through under driver side, passenger side not to bad, searched online only found complete floor pan replacement parts from Quadratec.

Do not need to replace entire floor pan only a good 4 x 6 inch piece any ideas?

I do have access to a welder and I am not to bad with a MIG.

Suggestions on thickness of sheetmetal 1/8?

Should I just not worry about bolt holes and plan on running bolts through and putting a nut on from underneath?

thanks

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 09:58 PM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC