|06-29-2013 05:28 PM|
|CrazyT||Also, I used Alloy gears, and I found that swapping the OE carrier shims left to right and using the OE pinion + .0005 or .0010 shims worked well to get initial ballpark.|
|06-29-2013 04:35 PM|
This is the best how-to I found:
I followed this when I did my gears.
Do you have a rubicon? If so, there are additional steps to deal with the factory lockers. You have to get the locker sensor on the correct side when installing, unless you can mess up the locker.
|06-29-2013 04:12 PM|
|06-28-2013 02:17 PM|
Did your gear set not come with install instructions? I can't find the link but I swear we found Yukon's online. My G2s came with directions but the Yukon was helpful also. But its all at home; if you can wait until Monday I can bring it to my office and scan all the docs. I posted some tips/tools when we did it.
Above all figure a lot more time than you think you'll need. And you'll be having dreams about gear patterns. My hair smelled like diff. fluid for a week but that may not be applicable to you. LOL.
|06-27-2013 09:50 PM|
Due to the nature of your question I highly recommend you look at this link.
Four Critical Ring & Pinion Settings
|06-27-2013 06:10 PM|
I used Poly Performance installation instructions (couldn't find a link, sorry) and my brother-in-law (a master mechanic) to do mine. I did all the work using his lift, tools and expertise. Was very straight forward, just time consuming getting the shim packs correct.
I've also heard of instructions on Randy's Ring and Pinion website, but could not locate them myself.
|06-27-2013 03:03 PM|
Help with Ring and Pinion
Need to change my gear ratio and have all the parts. I'm a experience mechanic but never done this to a Jeep. Anyone know of a good manual?