|06-27-2013 11:05 PM|
|daddyjeep||Looks good. the hoop follows the countours of the grille nice. The windshield looks better now without the bugs.|
|06-27-2013 07:39 PM|
|xxxxxxxxxxxtklein42||Definately weigh the finished product too. Useful when comparing to other bumpers. Front and rear weight can make a huge difference on spring applications|
|06-27-2013 07:31 PM|
|06-27-2013 07:29 PM|
|PissAnt||The fairlead is recessed by welding in a standard fairlead inside the bumper then smoothing up the external surface so it wont catch the cable. When I take off the bumper to finish the winch mount I will grab a few pictures.|
|06-27-2013 07:20 PM|
|06-27-2013 07:16 PM|
Thanks for the interest
|06-27-2013 07:08 PM|
|Jeep_Gypsy||Hmmm I'm jealous of your tube bending abilities. What are the chances of buying just the bent tube section?|
|06-27-2013 06:59 PM|
Thanks everyone for your feedback! My rear bumper is now in the design stages, I will keep you updated.
|06-27-2013 05:32 PM|
|06-27-2013 05:29 PM|
|06-27-2013 05:15 PM|
|xxxxxxxxxxxtklein42||That is sexy! Nice work man! How much you think it would cost to recreate? I would definately go for something like that!|
|06-27-2013 01:57 PM|
|06-27-2013 01:56 PM|
Ready for paint!
Sorry, I forget to get pictures of the primer stage...
Bed liner is on! I figure it may chip off easy but a can of Rustoleum only costs about $7 for touch ups.
|06-27-2013 01:55 PM|
The stinger is now attached but awaiting the support brackets
Supports brackets now attached to the hoop and stinger
Shot from the inside...please ignore the bug splatters!
So whats next for this bumper?
Whats next for the Jeep?
|06-27-2013 01:54 PM|
Creating the bumper's end caps comes next ...
One overall shot the bumper so far
Preparing to attach a set of D-rings
One of my personal favorites...the recessed winch fair lead!
Finally starting the tube bending process (following morning)
Initial Hoop finished and tacked on
|06-27-2013 01:52 PM|
Welding in place the new winch plate using a Snap On MIG unit. I am returning Saturday to finalize the winch mount (figured it needs more support to function safely).
Building the bumper's base ...
Attaching the lower skid plate to the bumper's base
|06-27-2013 01:51 PM|
Custom Fabricated Hoop Stinger Bumper
Some buddies of mine just started a small fabrication shop in Chandler. Like most start up business its based out of the garage to save on overhead (in turn allows for lower pricing too). Here is a photo shoot of the bumper I had them build for me over the past weekend. Enjoy!
Picking up the materials for the build. All 100% American made steel will be used in this build ... Except for the Chinese D-Rings
The shop being used for the build. Yes, its a garage but the quality came out fantastic as you will see later on.
Pictures of the bumper that is being replaced shortly ...
Let the fabricating begin!