|07-11-2013 12:52 AM|
Not sure I understand exactly but there are several places on the fuel line where it should be rubber. Because of flex upstream and downstream are different. Such as under the tank and seat. There is about a 4" length. That needs to be there.
Remember that frame twists and flexes like there is no tomorrow. If you make that fuel line or brake line for that matter, solid. It will break.
|06-28-2013 08:11 AM|
|lynn||Measure twice, cut once...|
|06-28-2013 12:04 AM|
|02tj-clayton||Just not too sure how long to cut the steel line to patch the two rubber lines|
|06-27-2013 11:23 PM|
|ksjeeper||Ya get those and you should be good to go.|
|06-27-2013 11:20 PM|
|02tj-clayton||I've got the compression fittings I just need to get the barbs|
|06-27-2013 10:43 PM|
|ksjeeper||There are fittings that have a barb on one end. You could put the barb on the rubber line and then use a compression fitting and screw that onto the threaded end. Your local part store should have them|
|06-27-2013 07:53 PM|
Fuel line spliceing
I had to cut the old rubber fuel line to check some stuff with the fuel pump and now I need to patch the part I cut and I've got a steel line to use to patch it