Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > YJ Jeep Wrangler Forum > YJ Tech Forum > YJ Just dies--PCM and Grounding issue

Join Wrangler Forum Today


Thread: YJ Just dies--PCM and Grounding issue Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
06-30-2013 08:33 AM
JaimeJ After few miles, all electronics & motor stops instantly. After restart - the engine stops sooner and more frequently. Mechanic said Clutch sensor, It checked out - OK. Rotor and cap replaced - not it. Replaced computer, also not the problem.
What else?
03-12-2013 07:26 PM
TonyGreen I am having a similar problem. I am goint to check this out. Thank you. it might be part or my entire problem. I did unplug the battery positive cable before. but not the ground and/or negative cable. It is worth a try, anything is game at this point.
03-12-2013 03:24 PM
4angrysquirrels welcome ambushtom great project.doing this soon.
03-12-2013 01:59 PM
jonathan75 Here is a link to read more about it and for product identification. I use it to clean off circuit boards as well.

DeoxIT® D-Series
03-12-2013 01:55 PM
jonathan75 For cleaning electrical contacts I always recommend Deoxit D5. It cleans very well and protects. I use it mainly for rebuilding vintage stereos and cleaning the volume pots. But I found it works great for anything electrical. I cleaned off corroded battery acid once with it and it was like new. For quick local pickup Guitar Center has it.
03-12-2013 10:36 AM
Fireman366 I have a 95 2.5 was rideing along and it just died im getting fuel but no spark I've replaced all the usual things plugs wires coil crank sensor does this sound like what was wrong with your jeep Sahara ?
02-19-2013 06:15 AM
ambushtom
YJ Just dies--PCM and Grounding issue

SHORT ANSWER: Disconnect the ground terminal from your battery vount to 30 and reconnect. This will sort of reboot the pcm. if your jeep starts up its all about the pcm or the ground cable. Check ground cable from battery to engine block and any other ground cables. you can buy a lifetime warranty pcm online for about 250 which is less than having a mechanic trouble shoot this mess. I am told the pcm internal power supply or capacitors fail over time and the unit becomes intermittent. I just ordered a new one but have yet to receive adn am running off teh reboot with a tightened ground cable which was slightly loose.

LONG ANSWER: I bought a 1994 Jeep Wrangler Sahara from a friend. Its in decent shape and my son and I are having a blast working on it and driving it. BUT when driving it would suddenly cut out. Fuel pump dead, coil dead etc. it would crank but not start, acting like it wasnt getting fuel. We rewired fuel pump changed coil etc. I read several threads and found a video describing a loose PCM that shook the plug out and caused same problem. Checked ours and bottom screw fell out and it was flapping against firewall. (The pcm is located behind the washer fluid bottle which is easily removed with one inboard phillips screw). it is a black box with three screws mounting it to the firewall. Also the screw holding the plug into the pcm had torn out and the plug had been glued in. I took it all apart and hit all the connections with chlorinated brake cleaner, reconnected and it is running fine now. I have read numerous threads describing the mysterious dieing and it coming back to the PCM and battery ground cable connections. Hope this helps, I was stumped for about a week.

Also installed a posilok device because the vacuum activiated 4wd is unreliable. I highly recommend this and there are several videos online showing the install.

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 06:11 AM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC