Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > JK Jeep Wrangler Forum > JK General Discussion Forum > Seeping Water Pump Seal

Join Wrangler Forum Today


Thread: Seeping Water Pump Seal Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
07-03-2013 10:46 PM
RKCrowe I ended up re-torquing the pump bolts and that almost fixed it. So I torqued the culprit area bolts a few more in.lbs and that seems to have fixed it.

Thanks for the support.
07-03-2013 07:04 AM
jmb6420 Let us know how it goes.
07-02-2013 09:26 AM
RKCrowe Thanks, I really knew that..but I had to try staring at it for a long time and psychically willing it to stop leaking first.
07-01-2013 06:52 PM
jmb6420 No. Take the pump back off, clean both the pump and engine surfaces of old gasket and RTV. Use a new gasket. Hand tighten all bolts then torque bolts (105 in/lbs) rotating 1/4 turn each time until all are torqued.
07-01-2013 02:30 PM
RKCrowe
Seeping Water Pump Seal

2007 Jeep Wrangler, 2dr, Sahara

40,000 miles

I just replaced my water pump. There was coolant seeping by the gasket at a couple of the bolts. I thought it was the bearings going bad so decided to replace.

Everything went by the book, removed the old gasket, cleaned all surfaces very thoroughly. I applied a very thin layer of RTV to pump and housing surfaces and also the gasket( I have read both to use RTV and not to use RTV with a gasket). Installed new pump, torqued bolts to 105 in.lbs

All seemed good but I noticed some seepage again around the same bolts, though not as bad as old gasket. I cleaned the coolant off and ran an errand and checked again. There was still some seepage but not as much as first time.

My question would be...is it common to have a little seepage at first, but will eventually stop when the new gasket gets "conditioned"?

Thanks for the help!

Richard

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 07:50 PM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC