Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > TJ Jeep Wrangler Forum > TJ General Discussion Forum > Fan Switch

Join Wrangler Forum Today

Thread: Fan Switch Reply to Thread
Post Icons
You may choose an icon for your message from the following list:

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:


Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.

Additional Options
Miscellaneous Options

Topic Review (Newest First)
12-19-2006 06:01 AM
Odhinn That is a strange situation you have. Sounds like you have a connection problem in the plug, or on the control switch. Might even be a corroded or bad ground. If it was just that the motor only blew in 1 and 2; I would say something with the connector on the control head or resistor panel. You having to go back to 1 to get 2 to work throws a loop into it. I would start with checking the wiring from the control head to the resistors looking for corrosion or damaged plugs/wires. One other possibility is a bad switch in the control head. Be aware that wiring problems will throw some pretty strange symptoms and could be attributed to something that will make you sit back and say "how the heck". Check everything before condemning the control head the way to check the control head switch is to ohm out the proper pins off the back of the control head and see if they are still showing good flow when the switch in on the proper place. (i.e. switch placed on setting 1 check pins for setting one).
12-19-2006 02:01 AM
blownfanswitch Thanks for the help. I'll use that thread to begin checking it out tomorrow. I've noticed something else as well. When I turn it up to 3 or 4 it stops blowing. It won't start blowing again on 2 until I go down to 1 and then back to 2. I'm sure that link'll help.

Thanks on the name.
12-18-2006 09:28 PM
Originally Posted by blownfanswitch View Post
My fan switch just quit blowing on speeds 3 and 4. Worked yesterday and not today, and I'm not sure why. Any suggestions as to where I should start?
i like your username. very creative. its cool.
12-18-2006 09:04 PM
Texapple this might help ya:
12-18-2006 08:44 PM
Fan Switch

My fan switch just quit blowing on speeds 3 and 4. Worked yesterday and not today, and I'm not sure why. Any suggestions as to where I should start?

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

All times are GMT -5. The time now is 08:40 AM.

Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC. is not in any way associated with the Chrysler Motors LLC