|07-06-2013 09:00 AM|
Mechanical linkages are a bit different than hydraulic linkages...
|07-06-2013 02:01 AM|
|Si_d_2003||So it's decided then....there is still air or having replaced the master, the slave has now weakend. Shall I pump the buggery out of it?|
|07-06-2013 01:00 AM|
When you release the clutch pedal, it should grab closer to the floor. The clutch works the same as brakes do, except opposite types of engagement.
To engage the brakes, you push on the brake pedal. I don't like to push it to the floor for my brakes to work, or fully engage.
When you let out on the clutch in a perfect world, it should start engaging within the first couple of inches from the floor. If it takes the full travel of your pedal to engage the clutch, that's like having to put your brake pedal to the floor to stop.
Go ahead and Google how to adjust a mechanical clutch, and the reasons behind it. With some hydraulic clutches, you are kind of stuck with what you got. But it still should engage and disengage on the lower half of the pedal if everything is working correctly. A worn out clutch, weak or leaking clutch master or slave, and air in the lines will all make the pedal engagement higher.
Its not rocket surgery, its just simple hydraulics. Don't over think it.
|07-05-2013 11:07 PM|
|07-05-2013 10:40 PM|
|07-05-2013 11:47 AM|
|Si_d_2003||Yeah the external slave has a threaded hole. But no hole drilled so I installed myself a nipple. People say the are pre bled systems but you can change the master and slave. You just knock the roll pin out and bobs your uncle. But do u guys think there is air still in there. I have tried pumping the slave manually with no more air coming out and I have gravity bled the system by just leaving the nipple open. But still no luck.|
|07-05-2013 11:03 AM|
|reno92||If you have the external slave, I believe those were a sealed unit with no bleeding (maybe why there was no nipple) I have not heard of anyone drilling it out but I guess it should work. I do know there have been many who end up bleeding the slave several times before fianlly getting all the air out.|
|07-05-2013 04:33 AM|
|Si_d_2003||Yes I did change the clutch master. Lol|
|07-05-2013 04:14 AM|
|Si_d_2003||I have a JY with an ax15 tranny. I just changed the master. And drilled the slave to put a nipple in. The slave did look newer but cant be sure.|
|07-04-2013 07:10 PM|
You did replace the clutch master and not the brake master? I'm assuming so, but just checking.
What year and tranny you have will help too.
|07-04-2013 05:24 PM|
|Xpress||Sounds about normal, most truck type clutches grab towards the end of the throw. If your clutch was grabbing in the middle, or the first half of the movement, you likely had air in the lines.|
|07-04-2013 05:17 PM|
clutch pedal high...
Hey guys, I've changed my clutch centre plate, pressure plate and release bearing about 2 weeks ago. And was advised my master cylinder my be faulty because it was hard shifting gears. I've replaced the master, and bled it up as best as possible, first time pedal went spongy after 3hrs, 2nd time it seems to be better but my clutch biting point is near the top now. Before it was halfway. Is there still air in do u think?