Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > JK Jeep Wrangler Forum > JK General Discussion Forum > AEV Dualsport SC 3.5" drive shaft connection

Join Wrangler Forum Today


Thread: AEV Dualsport SC 3.5" drive shaft connection Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
07-06-2013 06:08 PM
Packman0004 Thx. I ended up disconnecting the LH control arms, which allowed the front axle to float. Once connected, I used a ratcheting strap to pull my axles close enough to re-connect the control arms.
07-06-2013 06:12 AM
Wharfrat
Quote:
Originally Posted by kjeeper10 View Post
The boot in the middle covers the slip joint. Did you try extending it?

Some lifts require removing the DS To allow the axle to drop down without contacting the exhaust.
This. The driveshaft should extend if you pull on it.
07-06-2013 04:29 AM
kjeeper10 The boot in the middle covers the slip joint. Did you try extending it?

Some lifts require removing the DS To allow the axle to drop down without contacting the exhaust.
07-06-2013 02:24 AM
OffRoadCam09 Why did you remove the driveshaft while doin a lift kit?
07-06-2013 12:57 AM
Packman0004
AEV Dualsport SC 3.5" drive shaft connection

I have an '09 JK 4D and just installed this lift kit. My last step is to re-connect the drive shaft, but it appears about 2" too short now. Any suggestions?

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 04:35 AM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC