Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > General Jeep Discussions > General Jeep Discussion > 2.5 yj donut gasket?

Join Wrangler Forum Today

Thread: 2.5 yj donut gasket? Reply to Thread
Post Icons
You may choose an icon for your message from the following list:

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:


Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.

Additional Options
Miscellaneous Options

Topic Review (Newest First)
07-09-2013 11:05 PM
jokerchief462 Yeah they are a dealer part only place I could find them. They are pressed in from the top. Remove the exhaust manifold pound them out and then pound in the new ones and reinstall the manifold. That is how I did it took about 8 hours. They are expensive from the dealer but still available. Sucks but no room from the bottom.
07-08-2013 07:21 PM
YJ1990rav Alright, good to know. I will need to tighten them but i happened to strip the post taking it off so I will have to get them out after i figure a way to get to them!
07-06-2013 11:23 PM
jokerchief462 Yeah no donut required. The connection needs to be very straight. The exhaust pipe will actually tend to roll to one side when pitting it up there. IMHO the best and easiest way is to get both nuts started watching closely and give each side a few turns then the other to get it up evenly. Patience sucks but helps with that one.
07-05-2013 10:54 PM
2.5 yj donut gasket?

I am working on some exhaust leaks i have on my 1990 YJ and I realized i had one on my downpipe and tailpipe connection. In taking it off i noticed there was no donut gasket, i torqued the 2 bolts and still have a leak there. Is there a donut gasket for this model? If not is there a way to create a tighter seal around the flare?

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

All times are GMT -5. The time now is 08:08 PM.

Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC. is not in any way associated with the Chrysler Motors LLC