Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > JK Jeep Wrangler Forum > JK General Discussion Forum > Check engine light -P430

Join Wrangler Forum Today


Thread: Check engine light -P430 Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
07-08-2013 09:48 PM
legitposter I said 10 years, sorry. 8 is correct. Still, most people trade in by 8 years so its good.
07-08-2013 03:50 PM
Tomdata One more thing. Catalytic converters and most "emissions related" equipment is federally mandated to be warrantied for 8years/80k miles for all cars sold new in the u.s. after 1996. Vehicles with sulev and/or pzev (economy cars) emissions ratings have between 100-120k mile federally mandates emissions warranty.

The emissions warranty is separate from the standard 3 year 36k mile warranty that is standard on most new vehicles. Don't be scared of a trip to the dealer for the p0430 code if your under 8 years and 80,000 miles it will most likely be a free repair. The bad news is that if the p0430 code is the only code you had set you wasted a bunch of $$ replacing all those o2 sensors.
07-08-2013 02:38 PM
Tomdata P0430 is related to catalyst efficiency for bank2. It simply means the catalytic converter cannot reduce the emissions as good as it did when it was new and it has fallen out of the allowable limits. The PCM monitors rear o2 sensor activity and compares it to front o2 sensor activity. With a good catalyst the rear o2 sensor reading will be stable because the catalyst is using up the o2 in the exhaust to reduce hc and co while in closed loop. When the rear o2 sensors start switching rich/lean at a similar rate to the front i2 sensors it means the catalyst is no longer working efficiently and the PCM sets either a p0420 (bank1) or p0430 (bank2) code.

A catalytic converters efficiency can be reduced without it being plugged. Reduced efficiency often means a hollow cat
07-08-2013 02:35 PM
legitposter You should take it to the dealer. Dealers are very lenient when it comes to cat failure because it has to do with the emissions system and laws. Not only is it covered, by law, for 10 years but they'll also tend to ignore mods as the culprit.
07-08-2013 02:32 PM
ImpulseShot I'm not sure about your Jeep, but with mine I have to clear the codes with a code reader before the check engine light will turn off.
07-08-2013 02:32 PM
HOOCBB I've never used Sea Foam in that capacity. I'm not sure I would want to be crawling under/around the Jeep when it is producing the cloud of smoke.

Yes, generally a bad cat will cause sluggish acceleration, but most vehicles I have seen throw this code did not exhibit the same characteristics. For that matter, the ones that DID have sluggish acceleration didn't have the code.

Sadly, when dealing with cats, there is no hard and fast rule.

Just be sure to check the other items out before replacing the cats.
07-08-2013 02:19 PM
keltastic1 I saw on another forum, to try to run sea-foam through it. If there is an exhaust leak then it will smoke. Have you heard of doing that.
07-08-2013 02:15 PM
keltastic1 It has been on for over a year. From my previous experiences with bad cats, it makes the vehicle bog down and you have to really push it to go. I'm not experiencing that at all. It's been on now for over a year and my jeep runs fine. Will it run fine for over a year with a bad cat?
07-08-2013 12:44 PM
HOOCBB I'm guessing the code is actually a P0430...

Anyway, that code typically means you need to replace your catalytic converter(s). I was taught that the cats don't go bad without something else causing it (too much fuel, burning oil, etc), but was told otherwise in one of the stealerships I worked at.

Regardless, according to obd-codes.com, the 3 main causes for this code are:

Catalytic Converter not functioning properly
O2 sensor not reading (post cat)
Exhaust leak

Check all three before jumping to conclusions, especially since cats are not particularly cheap.

OBD-II Trouble Code: P0430 Catalyst Efficiency Below Threshold (Bank 2)
07-08-2013 11:30 AM
keltastic1
Check engine light -P430

I have had the check engine light on for over a year. We checked the code and it says P430. We have replaced all O2 sensors and the light won't go off. Any one else have this problem? I have heard that the unlimited have been known to have problems with the manifold, so we were thinking of looking into that.

2007 Jeep Wrangler X unlimited

Thank You,
Kelly

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 09:24 PM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC