Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > TJ Jeep Wrangler Forum > TJ Tech Forum > 97 4.0l error code 72

Join Wrangler Forum Today


Thread: 97 4.0l error code 72 Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
06-30-2009 08:03 PM
birdhunter I would guess a clogged cat also
06-30-2009 06:13 PM
slf41002 I would check the temps in front and behind the cat and also the temp of the cat itself.If the cat is much hotter that the pipe in front of it,it is clogged.If it is 100* or more hotter then something is causing the engine to run too rich.This should be done after running the engine for about 20 minutes.Check the temps and let us know what the readings are.If you don't have a thermo gun find someone that is into nitro powered R/C cars.They will have one.I just noticed you had an idel problem before,,,,Was it running rich then??? If so that will burn the cat out.
06-30-2009 02:49 PM
nagymjr
97 4.0l error code 72

Hey guys,

I'm looking for some thoughts and insight. My 97 Sahara popped up a check engine yesterday. Today i drove it to work in the morning with no problem. Looked up the code listing and checked it at lunch. It is giving me a (72) "Catalyst efficiency below required level. (Same as code 64)".

Now, I am driving home on lunch break and she starts hitching or dropping power occasionally. I let it sit for 30 min at home. Come back out and everything starts up fine. The code is still there so i take it around the block and it is pretty rough dropping out like it may stall. Then it is ok for a bit and goes to rough running again. Pulled back in drive way let it idle and it was all over the place.

ANY THOUGHTS ON WHERE TO START??

History: 200k on it. Fresh rebuilt transmission, Cleaned IAC a while back and took care of idle problem. Has 250miles on new plugs, wires, dis-cap, rotor, air filter, Crank sensor. All has been good since the tune up till now. I do have a cracked exhaust manifold and a leaking valve cover gasket, but they have been there from the beginning and never affected normal running before.

??? Cat, O2 sensors, Exhaust, Something else????

Thanks in advance.

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 02:20 AM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC