|09-08-2013 07:12 PM|
|Johnny6||Wish I would have put these inserts on mine. I drove through a nasty hail storm the other day and really banged up my radiator.|
|09-08-2013 06:52 PM|
|09-08-2013 06:41 PM|
|Aseventyfive||Any tj's have pics of a mesh grille?|
|09-08-2013 06:35 PM|
I have the RR ones and love them, and good looking also. No air flow problems at all. Easy to install too.
|09-08-2013 07:30 AM|
If you want to improve cooling get an aftermarket transmission cooler.
Even my hyundai has a mesh there. Seriously, the cheapest crappiest sounding brand name. Seriously, the door panels are just hard plastic.
|09-07-2013 03:01 PM|
I've seen some vehicles that are wide open in the front with no grills, the same as our jeeps. It's really sad that they are like that. I want protection for my radiator units.
On the more air flow. You can always put fans on the outer side to blow & the inner ones will suck. Extra cooling!
|09-07-2013 06:28 AM|
I would be more concerned about reduced rock flow.
The jk is the only vehicle on the market that i am aware of with no radiator rock flow reduction device. I also own a truck with a 12 liter turbodiesel engine which came with a rock flow reduction device from the factory. And i think that 12 liter needs all the airflow it can when its pulling an 80,000 lb truck up a mountain
|09-07-2013 12:53 AM|
|07-13-2013 11:16 AM|
|07-13-2013 10:15 AM|
|07-13-2013 09:37 AM|
|BleedsGreen||Thanks for the responses and the information everyone!|
|07-13-2013 08:41 AM|
|kik||It's a non issue. For the most part, every other vehicle manufactured has a grill insert/covering of some sort for protection. It actually should be installed from the factory, but I guess it keeps the cost down. It's probably one of the best mods you can do for protection and appearance. There is no affect on cooling. In fact, it can only increase cooling efficiency by keeping foreign material out of the cooling vents of the radiator. Plus, it will deflect any road hazard from damaging the radiator.|
|07-13-2013 08:26 AM|
|Raiderfan001||It's been a non-issue for me and mine is I think more restrictive than most mesh ones.|
|07-13-2013 08:13 AM|
|blkrubi88||My TJ ran at 210 before my home made inserts and runs at 210 after home made inserts.|
|07-13-2013 08:02 AM|
|Martin10||I would not worry about reduced airflow at all. If you were able to hook one of those inserts up to a flow bench I doubt you could measure ANY difference with or without it. It is mesh after all.|
|07-13-2013 07:54 AM|
Grill inserts - effects of reduced windflow?
I've seen a lot of threads about grill inserts, both DIY and the purchased goods. And I agree they look fantastic, but has anybody have any information on how much they reduce airflow through the grill?
I know its kinda an extreme case, but I don't want to make my cooling system work overtime for a little bit of bling. Or have something without a temp gauge like my trans overheat.
On a related note has anyone noticed a difference in mileage? Considering the Wrangler has the aerodynamic profile of a brick I would be surprised if a little mesh mattered, but I am curious.