Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > JK Jeep Wrangler Forum > JK General Discussion Forum > Leaking axle seal

Join Wrangler Forum Today


Thread: Leaking axle seal Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
07-16-2013 01:12 AM
Lusus_Naturae
Quote:
Originally Posted by jkmohican View Post
^Whoops, re-read it and misunderstanding on my part, sorry!

I know about the diff cover leak, which I thought you were referring to, I know nothing about tubing leakage. I really haven't heard much about this, so sorry I'm of no help, hopefully you guys figure this out!
Actually you both are right. There can be a full drip leak and just seepage occurring at the axle seal tube too. The TJ had a seal seeping really slow for awhile, all you would see was a grease mark along the bottom of the inside tube at the end where the plastic dust cap was.

I finally had it torn down under warranty at 70k because it started to drip. It wasn't much, just a few drops an hour maybe, enough to see on the driveway after sitting all night.
07-16-2013 12:19 AM
BRUT4CE
Quote:
Originally Posted by WatchThis! View Post
The JKs have cups before the seals so the seals are less prone to damage but it does happen sometimes. Not very often in my experience. Good call on the end seals, assuming there are no sleeves eather. Of course if going this rought it wouldn't hurt to put just a little extra oil in the diff since the tube will be holding oil.

I wonder how much would collect in the short tube on a setup like this?
Don't know...

The rubber still protrudes past the recessed press spot and seal against the axle which splines are generally a smidge bigger and there's no way to center axle so a lot of times it drags through the seal...

But here's a concern for people who do them, (alloyusa outer axle seals) make sure that if you have a leak from the inner seal the pressure from turbulence will generally force oil past the seal which won't pass back into the diff housing...
Make sure to check the oil height regularly at first....

Just gave scott a set Saturday when we welded his truss on, he's been leaking for a couple months now and every time he goes through water he pukes milkshake on the ground...
(Oil and water milkshake, mmmmmmm.lol)
07-16-2013 12:03 AM
WatchThis! The JKs have cups before the seals so the seals are less prone to damage but it does happen sometimes. Not very often in my experience with new seals at least. Good call on the end seals, assuming there are no sleeves eather. Of course if going this rought it wouldn't hurt to put just a little extra oil in the diff since the tube will be holding oil.

I wonder how much would collect in the short tube on a setup like this?
07-15-2013 11:57 PM
BRUT4CE The seals sit right by where the tubes go in the housing and its not uncommon to nick one or have one get messed up a smidge when sliding the axles back in....I did it on my last next and this one I replaced the seals before axle install. They get damaged easier the older they are heat and the environment they are in hammers them...

If you dont have rcv axles you can get away with pulling an axle and slapping alloyusa end seals in...
07-15-2013 11:38 PM
WatchThis! Hey man its all part of being on a forum
07-15-2013 11:32 PM
jkmohican ^Whoops, re-read it and misunderstanding on my part, sorry!

I know about the diff cover leak, which I thought you were referring to, I know nothing about tubing leakage. I really haven't heard much about this, so sorry I'm of no help, hopefully you guys figure this out!
07-15-2013 11:08 PM
WatchThis!
Quote:
Originally Posted by jkmohican View Post

I meant that this is the answer for the OP to figure out so we can help him, come on you knew what I meant!
No man actually I didn't. The post you quoted was talking about oil building up or driping from the housing and the OP said he had an oil leak from an axle tube. Apples and Oranges, and a simple misunderstanding.
07-15-2013 10:43 PM
jkmohican
Quote:
Originally Posted by WatchThis! View Post

Actual it is not. The question was about an inner axle seal leaking not a diff cover leaking.
I meant that this is the answer for the OP to figure out so we can help him, come on you knew what I meant!
07-15-2013 10:21 PM
WatchThis! You have to seat it so I don't see how you could get it in to far.
07-15-2013 10:00 PM
Oakley25 Is it possible to push the new seal in to far making it not seal right
07-15-2013 09:17 PM
WatchThis! That shouldn't be enough to cause a leak then. All the ones I know that get overfilled are with aftermarket covers. You could try leting a little out and seeing if it helps before tearing into it. Just remember that oil that is in the tube will still come out for a while. Last time I checked mine I parked it down hill and sprayed B12 up in the tube to make sure I wasn't seeing oil that was already there.
07-15-2013 08:51 PM
Oakley25 Stock
07-15-2013 08:46 PM
WatchThis! With the stock cover or something aftermarket?
07-15-2013 08:31 PM
Oakley25 Well I filled it up to the plug but the front end was jacked up a little.
07-15-2013 08:18 PM
WatchThis! How over full is it? I have personally seen 4 JKs that will do this and a little oil out of the tube sure does make a big mess don't it.
07-15-2013 08:05 PM
Oakley25 Well I actually replace the seal saturday night. I hate to tear back in to it so thats why i figured i would ask first. so you think i need to run a day or so to see if it levels out? And yes, the guy helping me has never heard of overfilling it makeing it leak
07-15-2013 07:56 PM
WatchThis! Good question. Almost everyone I have seen do this does it on the drivers side for some reason. Mine does the same thing. Of coures you can also have a bad seal and might have to replace it which would require tearing the diff down again. Its a lot cheaper and easer to see if it will level out first as long as you don't let it get to low.

Have you brought this up with whoever did the gear install?
07-15-2013 07:36 PM
Oakley25 Well why doesnt it leak on both side? And it is leaking. It slings oil all over the inside of my tire and the inner wheel well.
07-15-2013 04:29 PM
WatchThis!
Quote:
Originally Posted by jkmohican View Post

This is your answer, OP.
Actual it is not. The question was about an inner axle seal leaking not a diff cover leaking.
07-15-2013 04:27 PM
jkmohican
Quote:
Originally Posted by Seeuoffroad View Post
Leaking or weeping? Leaking normally there is a drip = not good. Weeping you may get a little build up around the housing = that's ok.
This is your answer, OP.
07-15-2013 04:27 PM
Seeuoffroad Leaking or weeping? Leaking normally there is a drip = not good. Weeping you may get a little build up around the housing = that's ok.
07-15-2013 01:28 PM
WatchThis! Yes overfilling can cause it to leak at the seal. It will "find it's level" sooner or later or you can drain some out if it is making a mess.
07-15-2013 01:15 PM
Oakley25
Leaking axle seal

I just replaced my gears on the front of my JK unliminted sahara. Its now leaking out of the driver side tube. Can this be cause by hving to much fluide in the case?

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 04:32 AM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC