|09-09-2013 05:36 PM|
Update: Thanks to another guy on the forum having the same issue, I found out that the circuit board in the gauge cluster was burnt out. I took it to my buddy who builds computers to see if he could sodder a jump wire and he said it wouldn't work with how bad mine was burnt out.
I found a replacement gauge cluster on ebay for 75.00 with the same mileage. I saw others for 150.00 to 195.00.
I would verify you have a burnt circuit board and get a new cluster.
FYI the dealership wanted 950.00 for one!
|08-15-2013 11:00 PM|
|outofmoney||Did this ever get fixed? I am having same issue! No dashlights or hvac lights.|
|08-05-2013 11:46 PM|
|07-30-2013 01:44 PM|
|Lowrollin12||I will let you know when I find it... Don't have the patience for it for the next few days... Luckily its manual so I know how fast I am going at night.|
|07-29-2013 04:58 PM|
|07-29-2013 04:46 PM|
|Lowrollin12||So I got the MF switch from Rockauto very quickly and unfortunately that isn't the issue #facepalm! So I am back to the drawing board..... Bad wire somewhere....|
|07-26-2013 08:11 AM|
I am going off memory from my Automotive Electrical classes from 10 years ago but you can test a circuit with Ohms on a multimeter if you are having a bad wire issue. Someone will correct me if I am wrong but any complete circuit has to have resistance so if you get a 0 Ohm rating that is a bad ground or wire.
Again, going off memory but I used to use this test on my old Sport.
|07-26-2013 08:07 AM|
|Lowrollin12||Yea, my issue is a little different. I am not blowing fuses. Checked them all. The MF switch is the issue. I talked with Rockauto and it is covered under warranty. So I have to take back my last statement. blowing fuses is completely different from my issue. I will let you know when the part arrives tomorrow but I don't have any power coming from the switch with the ground and fuses all good.|
|07-23-2013 02:18 PM|
|jeeptjrider||That's what I'm thinking of doing|
|07-23-2013 02:14 PM|
|Tiburon||I've had the same issue in my 06 SE too. First time it happened the stealership said I had pinched a wire when I removed my steering column.... since it was just shy of 3 years old and I had never actually removed the steering column (seriously???) They covered it under warranty. Flash forward 2 years and it does it again. Now its not covered and damn if I'm going to pay 100 bucks an hour for them to diag it. I tracked down all the wires inside the switch and found the one that should be activated when the switch gets turned on, no power from it. I used a length of wire and a rocker switch to temp bypass it (for the last 2 years) until I get a replacement switch. I guess its good enough for now and keeps 150 bucks in my pocket for a little while longer.|
|07-23-2013 12:46 AM|
|jeeptjrider||I tried that and even went with the big fuses in the engine compartment and still n blowing I pretty sure its a short now somewhere and have looked and found nothing.. So just keep looking for now i guess|
|07-22-2013 10:20 PM|
I recently had a similar issue. I would double check that your 5amp fuse is not blown. I know you said that you checked the fuses but most people don't think to check the 5 amp fuse. If you do find that this fuse is blown, you will probably find that it keeps blowing if you replace it. Disconnect the Heater and A/C lights and then try replacing the fuse. If it doesn't blow that's your problem. That's what happened to me. Everything works fine for me but I don't have lights on the HVAC.
Basically just keep disconnecting things that go to the fuse that's blown until you find what's causing it.
|07-22-2013 04:54 PM|
|jeeptjrider||I have the same problem but my park lights are also not working interior yes turn signals and emergencys yes dash n park no.. My fuse blows right away also|
|07-22-2013 04:36 PM|
|07-22-2013 11:45 AM|
|T2000J||You got power to the switch ? Check the big fuses under the hood ?|
|07-22-2013 11:27 AM|
|Lowrollin12||well Rockauto doesnt do returns after 30 days.... LAST TIME I USE THEM! I had the switch in the truck for less than 4 months. time to go to the stealership!|
|07-22-2013 11:23 AM|
The ground is good but I am not getting power to gauge cluster or heater controls.... with the dash apart I found the illumination power and wasnt getting anything.
I think it is a bad MF switch I got from rockauto.com when my fog lights weren't working. Now I cant even turn on my int lights with the switch, this is the same ring you turn for brightness on my guage lights. Going to talk with rockauto and see how they handle this...... GREAT! I will keep you posted if this ever happens to anyone else.
|07-22-2013 10:40 AM|
|T2000J||Check the 40amp fuse in the motor compartment ?|
|07-22-2013 10:28 AM|
|Big Sarge||Sounds like it could be a ground issue. Have you recently replaced your front speakers? There are ground wires by the front speakers and IIRC they are grounds for the cluster.|
|07-22-2013 10:20 AM|
|Lowrollin12||1st thing I checked but I figured the gauges would be powered together. No blown fuse. I have it apart now. going to trace the power for the illumination. I am surprised no one else has had this issue here.|
|07-19-2013 12:52 PM|
|WorkingMan||Start by checking for a blown fuse first. It is the mostly likely and easiest to fix problem. Then look for more oddball issues.|
|07-19-2013 12:47 PM|
|Lowrollin12||Also what I found odd, the up shift, flog light, brights and engine light were all working. I didn't think they would be on a different circuit.|
|07-19-2013 12:46 PM|
Gauge Lights out but gauges working
Yes I did search and only found issues with YJ's. This is for my 03 Rubi.
The gauges work fine but last night the lights all went out for gauges and heat controls. I am going to start looking for a bad ground or corroded wire but I wanted to see if their was a common problem with the TJ's before I rip the dash apart.
I did say I needed some busy work for the jeep but I was referring to locker compressor relocation and on board air, not searching for a bad ground!