|03-11-2014 08:28 PM|
|Tiaan||Hi guys, I have done everything the thread shows to the T. I am still off by 10 mph fast on my speedometer. I have d44 with 3.73 and 33s so I should run the 31 tooth speedo gear. The tab on the diff cover says it is a 3.73 but iam starting to question that now. Any advice would be greatly appreciated .|
|01-03-2014 06:09 PM|
|Sourmash||Ok, so I reread the thread and found the ratio. I've got a '97 TJ, Automatic, Running 33" Toyo's, with 3.07 gear ratio. I see on the chart in this thread that it says 26 tooth, my question is almost every other chart I've seen doesn't show a size for the 3.07 and 33" tires, I dont fully understand gear ratios but can someone explain in layman's terms why they wouldn't have one for that combination? Is the 26 tooth the closest I will get to accuracy?|
|01-03-2014 03:49 PM|
|Sourmash||At the risk of looking like a total idiot, can someone tell me how to confirm the gear ratio?|
|10-02-2013 05:14 PM|
|JT42||Ahhhh yeah I bet it is security since I pulled up the page from my work laptop. Appreciate the answer and the reposted picture. Cant wait to get this done. I will order the new gear tonight!|
|10-02-2013 04:20 PM|
Here is an attached photo of the ratio line up.
Find the numbers on your speedo falls under "tooth count".
Line them up at the 5 o'clock position of the hole. "also lines up with where the wishbone clamp sets in the plastic housing.
Since you have a 39tooth gear yours should look like this.....
|10-02-2013 04:13 PM|
|10-02-2013 03:18 PM|
Wow this is awesome! When I re-geared my Dakota I had to have the dealership do a flash and since they didnt have a chart it was trial and error until we got it right.
Since I have an 03 TJ Sport with 33's and 4.56's I understand I will need a short shaft 39 tooth. My only question is, did the original post intially have pictures to go along with the write-up or was it always just the step-by-step instructions? I am not sure I fully understand the rotation deal and think pics would help me before I tackle this.
|07-23-2013 03:48 PM|
You've got a 34.4" tire http://www.quadratec.com/jeep_knowle...article-46.htm
|07-23-2013 03:35 PM|
|Rewind||Yes it's a TJ.....According to the Vin I have a 3.07 axle ratio.|
|07-23-2013 03:22 PM|
|07-23-2013 03:18 PM|
|Rewind||How do I tell which speedo gear I need to compensate for the larger tires (315/70-17)|
|07-23-2013 01:43 PM|
|AlexS||put your transfer case in neutral. jack up the rear end of your jeep. Spin your rear tire around once and count the number of times the drive shaft spins. That will roughly tell you what gears you have|
|07-23-2013 12:22 PM|
|07-23-2013 12:03 PM|
|07-23-2013 11:15 AM|
|Rewind||Ok, this is interesting........there is no speedo gear tooth count listed for my set up. I have (according to my vin) a 3.07 axle ratio and I'm running 35's. Any ideas on which one I need?|
|07-20-2013 10:20 PM|
|07-20-2013 09:58 PM|
|07-20-2013 03:56 PM|
|07-20-2013 01:23 PM|
ALL TJ np231j cases use a short shaft.
All TJ rubicon np241 do NOT use a gear driven speedo. But a tone ring. You must have a dealer reprogram the comp to the correction or use a aftermarket programmer to adjust it yourself. "i'd use the programmer'.
|07-16-2013 02:05 PM|
|RevCo666||How does one know if you need a short or long shaft version of a speedo gear??|
|04-17-2013 12:16 AM|
|04-16-2013 10:01 PM|
let's bring back a dead thread....
I just bought a 1993 jeep wrangler with a 4.0l with 35" tires and 4.11 gears. I wondered if my speedo gear was swapped out so I crawled under it and yanked the gear out. Turns out it was changed to a number 35; this doesn't line up with the chart though.
How will this affect my current millage and mpg? Should I swap it for a 34? When I used my gps and compared it to my speedometer I am going 1.11 miles for ever 1 mile shown on the speedo.
|03-08-2013 08:56 PM|
|871kevin||Does anyone know if there are numbers on speedos that are cable not electronic? I don't know what to turn it to|
|02-28-2013 04:47 PM|
"Tru-speed" I believe it is called made by superlift is a decent speedo recalculator.
|02-28-2013 03:32 PM|
[QUOTE=distortedtj;2615886]As noted before. The Rubicon 241 t-case uses a tone ring. You can only fix the speedo with a computer flash or programmer that has the option to adjust the speedo gear for tire size.
So this will NOT work if you have a JK or the RUBICON version of the TJ? Just want to clarify this....I saw it won't work for a JK but seemed to miss the RUBICON...
I have an 06 Rubicon manual transmission...
-EXCELLENT WRITE-UP BTW!
|02-19-2013 07:31 PM|
|02-19-2013 07:07 PM|
|Godric||This post is super helpful, the only way to make it easier is for you to do it for me!|
|01-29-2013 10:35 PM|
Without swapping the gear you are not getting a correct MPG reading on your Odometer.
|01-29-2013 03:51 PM|
|Quest4life||Awesome post. I know for a fact I would have missed the gear number on the housing! Thanks i am sure you saved me time and anguish!|
|01-29-2013 03:46 PM|
|hickdubious||Will replacing the speedo gear help increase MPG?|
|This thread has more than 30 replies. Click here to review the whole thread.|