|12-26-2006 07:26 PM|
i hope my springs are in right because they weren't marked!
|12-26-2006 07:25 PM|
|bluvikng||I did not know that it was a standard thing, unless they put the right springs, on the left side. I know my lift had passenger side, written on two of the springs. Anyway, sorry about my comment, it was totally uncalled for. I will bow out of this conversation, cause my two Jeeps sit very level, and I thought they all did.|
|12-26-2006 07:18 PM|
they said it was "a Jeep thing"
|12-26-2006 06:03 PM|
|ChilliRed||My jeep is a little cocked as well, cant tell if your driving it, but its a little noticable after you know its weird. Since it doesnt seem to be messing anything up i havent looked into it much. Its just one of those dumb things that never seem to get fixed haha.|
|12-26-2006 02:21 AM|
well my tj leaned to the right and I was doing three wheel left turns with the rear sway bar connected. Never did it till I did the axle swap.
Turns out I had the right rear coil in wrong turned it around and it feels more stable and I cant do three wheel left turns any more.
|12-26-2006 01:44 AM|
|18derrick||Get a bigger copilot !|
|12-26-2006 01:27 AM|
|bmxstreet15||Tire pressure is good, I bought the jeep with the lift on it already. I am planning on going to a fabtech long arm 6 inch though. 4 inches isnt enough clearance. Springs are seated properly. all bolts are tight. I cant figure this out. Maybe its because I never have anyone in the passenger seat? I am going to swap the rear springs just to see if it leans the opposite way when I do this. If it does than it is most likely a spring, right?|
|12-25-2006 09:33 PM|
|bluvikng||Damn, now I feel bad about my comment to bigjeep. It is all good bro, and I am just doing the best I can to help someone that isn't sitting right. Forgive my impatience, in trying to help someone out.|
|12-25-2006 09:27 PM|
|hardy1531||I am not smart or anything but have you checked air pressure in the tire? I like to think it is always something easy...( but I know the truth, it never is)|
|12-25-2006 09:23 PM|
|12-25-2006 08:24 PM|
|mr4x4||did you instaal the lift. Did this just start to happen.|
|12-25-2006 07:03 PM|
if its just a half inch then i don't think its anything to worry about.
a while back a guy was doing before and after measurements and his leaned also. if i recall correctly then it was at least an inch.
|12-25-2006 05:23 PM|
|12-25-2006 05:18 PM|
i didn't get coal!
|12-25-2006 04:21 PM|
|12-25-2006 03:53 PM|
|tiny terror||Naw, BigJeep's just lousy at teasing cuz he's always so serious , no switching gears.|
|12-25-2006 03:47 PM|
|12-25-2006 03:42 PM|
|mr4x4||is your jeep lifted or stock|
|12-25-2006 01:58 PM|
it was a joke, hence the big smiley
|12-25-2006 11:31 AM|
|12-25-2006 11:19 AM|
|bmxstreet15||Is that really possible? The jeep only has 20K miles and i only weigh 150!|
|12-25-2006 10:34 AM|
|mrbigjeep||maybe its cause your sittin in the drivers seat all the time making it sag|
|12-24-2006 10:00 PM|
|bmxstreet15||Ok thanks, Well I drove it around a bit and it still leans but now it is only 1/2". It is still noticeable though. The springs are all in thier pocket and the shocks are old but still working. Could it be that my front sway bar is out of adjustment?|
|12-24-2006 07:20 PM|
|bluvikng||You can get them through your dealership.|
|12-24-2006 07:18 PM|
|bmxstreet15||Well, this gives me an excuse to get new/better shocks. Where can I get those retainer clips?|
|12-24-2006 05:18 PM|
Your springs do not have retainer clips on them, to hold them in place on the seating plates. Make sure the ends of your springs, are sitting in the proper place, on the plates. I have had to adjust ours, a time, or two. You can buy the clips, to hold them in position, but they do not come with them. Go figure.
This usually happens after flexing to the max.
|12-24-2006 05:14 PM|
|chucky cheese||I have found with chrysler products if the ground is not level you will not measure evenly around vehicle|
|12-24-2006 05:06 PM|
|amerijeep||My first guess would be a possible broken shock.|
|12-24-2006 04:56 PM|
Ok so i got home today from a trip into town and notice that my jeep was leaning to the drivers side. I did some measuring and it is sitting about 1/2-3/4 of an inch higher on the passenger side rear wheel. the front is only 1/4 inch high on the passenger side. I am stumped. Should I try driving it around a little to see if it levels off? I have no Idea what would cause this. I need some help here.