|08-06-2009 11:33 PM|
1500 miles and not a SINGLE death wobble!!!
To anyone with DW - if you are due for tires and/or alignment, start there first. I could have driven myself crazy searching for a suspension issue when it wasn't necessary.
|07-31-2009 10:55 PM|
|cougforester||for what it's worth this long after the original post - my 06 unlimited developed this same thing out of the blue. a balance of all four tires cured it.|
|07-31-2009 02:17 AM|
|TheBostonWrangler||I got the tires and so far (50 miles) it took away the death wobble and most shimmies too. I went out and got some automotive degreaser/cleaner - I couldn't see most of the connection points on the suspension to determine if anything is worn.|
|07-30-2009 03:15 PM|
|07-29-2009 11:25 PM|
It's been pouring rain here in Philly so I haven't been able to get under the Jeep (on dry ground) to inspect the front end. So I did something blasphemous...I took my CBR out of the garage and put it in the rain, along with a LOT of other stuff, so now I can fit the front end of the Jeep in to the garage. Im not that great with this stuff, so Im hoping to be able to AT LEAST point my mechanic in the right direction.
Since all I ever do is ask questions, Im going to try to make a contribution to the other mechanically challenged folks out there by posting a diagram of the front end of the Jeep. This way, if we have questions about something that may be a DW culprit, we can ask it in an intelligent manner (instead of, "Hey, the bolt that attaches the short shiny bar to the long rusty bar seems a little loose...any ideas?").
Hopefully this helps someone. By the way, this isn't my write-up so I dont take credit (or blame) for what is here. I got it from a Jeeper on another blog. If anyone wants to add what we should be looking for, feel free.
Tips for inspecting front end issues relating to shimmies or DW:
1. Control arm bushings - if they are worn, you may get play in the axle.
2. Tie rod ends - ensure greased, intact, and no lateral movement (may have some rotation due to the joint type).
3. Track bar - check BOTH ends (frame and axle)
4. CV joints - jack tire up and check for motion top to bottom /\ kinda thing.
5. Draglink/tie rod. make sure that connection is secure as well.
If the problem has cropped up, you should also ensure your tires are properly balanced and have even wear.
IF you replace the steering stabilizer/dampener, I'd suggest at least getting a good aftermarket one, like Old Man Emu or something. That stock unit is so so. That will be my next acquisition.
If you look at this pic, you can see the primary components for the front suspension. Any of those points being loose can create havoc.
|07-29-2009 09:31 PM|
|07-29-2009 04:32 PM|
The front end could be out of wack...I still need to get tires and alignment regardless.
|07-29-2009 03:27 PM|
Assuming you have a TJ and not a YJ Wrangler, you can easily run 31x10.50 tires on your 15" wheels without issue.
So far as your DW is concerned, make sure your trackbar mounting bolt (at the axle end) is tight and its mounting bolt holes are not wallowed out. If the trackbar can move at all (it can be too loose even if you can't move it with your hands), it can allow DW to develop after being triggered by something like out of balance tires, bump in the road, bad (loose) ball joints or unit bearing hub, etc.
There's a nice FAQ on Death Wobble at the top of the TJ Jeep Wrangler Tech forum.
|07-29-2009 02:44 PM|
|07-28-2009 03:53 PM|
|07-28-2009 03:10 PM|
|TheBostonWrangler||Thanks for the hi-jacking. Much appreciated.|
|07-28-2009 02:24 PM|
|duncan malloy||I just bought a 2002 wrangler sport with a 1.75 inch lift kit. The tires on it now are Michelin LT 31x10.5x15. I know the tires need replacement but the front end seems to want to drift and my wife says it feels top heavy. What do you recommend?|
|07-27-2009 12:26 PM|
|Sb5551||My reccomendation is BFG all terrain. They will last forever. They will fit on a stock jeep with minor rubbing when you turn the steering wheel all the way to one side.|
|07-27-2009 11:11 AM|
|kirkf||I am also looking for a tire that is good looking but yet affordable for my recently purchased 2004 Sahara. These tires will be used 98% on pavement. Wanting 31 x 10.5 x 15. Any help would be greatly appreciated.|
|07-25-2009 04:54 PM|
|TheBostonWrangler||I have a 2003 Wrangler - can I put 31" tires on the stock 15" wheels?|
|07-25-2009 04:10 PM|
Gotta Death Wobble - Gonna Start w/ new Tires
I think my wobble is due to really bad alignment which has caused my tires to wear WAY uneven.
So I want to replace the tires. My current tires are Goodyear
Can someone recommend a 31" tire that my stock 15" wheels will fit on?
Or possibly a link for a good wheel/tire combo? I thought Quadratec offered combos but I cant find them on their website.