|08-27-2013 08:16 PM|
Today I ordered adjustable control arms and adjustable track bar. I will install them when they show up and have alignment done. I have not checked torque yet as I got it home and it has sat in front yard.
|08-27-2013 04:01 PM|
The shop did the break in on the gears. Told me to drive it 500 mile then change fluid
|08-27-2013 01:42 AM|
|08-27-2013 01:34 AM|
were you stopping to break in the gears and let them cool? Hopefully the shop explained the break in period to you knowing you had such a far drive back.
Also y our abs kicking in is most likely just the drag link needing adjusted as others said. This has happened to me a couple times now after wheeling.
ALso was the wheel crooked when you picked it up? i can't imagine a shop noticing that and letting it go out the door like that.
When I was thinking of getting a truss I was advised to let someone with experience install it so that it didn't bow the axle. I'd lay a level across it and make sure everything is still straight.
Have you checked to make sure everything was torqued down?
|08-27-2013 12:32 AM|
Well they said they drove it several times. All was good.
Ruby Tuesday.. I know sorry for the mess of a thread I was on the way home and was stopping along the way posting while trying to stay calm...
|08-27-2013 12:18 AM|
|Ruby Tuesday||Hard to follow this thread|
|08-26-2013 11:54 PM|
|Kevlars||does not stop the distracted worker ... it happens ... if they are that recommended they will take care of you. You may want to ask them if they took it for a test drive to make sure all was well.... certainly if you had issues .. it was not.|
|08-26-2013 11:49 PM|
Pulled the Dip stick all seems fine. Oil level is about where it should be. Had a decent amount of metal shavings on the stick though gears and locker have 250 miles maybe on them.
I am concerned with oil coming out water will go in. but the shop that did the work has been around for a long time 20ish years I am told, and come highly recommended from 3 different forums by many people. Guess I am not mad because I am sure they will take care of me. Just wondering how my Jeep is going to get back to shop cause I am not driving it.
|08-26-2013 11:14 PM|
No but had it towed home... just sper over 6K I am sure they will take care of me but I have, both coil sprindle severely bowed inward, bolt for track are is hitting truss has tire up bolt and face of truss, oil leaving for a le seal, sway bar where it connects to disconnect is hitting coil spring.
Shop is 3 hours right at 200 miles away.
|08-26-2013 10:50 PM|
|kjeeper10||Do you have a alignment sheet ?|
|08-26-2013 10:06 PM|
|08-26-2013 10:01 PM|
|08-26-2013 09:56 PM|
|HAFICON||Just Lewellen axle seal yes I'm getting towed|
|08-26-2013 09:55 PM|
|Tweak||grab a 15mm wrench and spin that turnbuckle. the steering "locking up" was your ABS and ESP thinking you were in the movie Tokyo Drift when you were actually trying to go in a straight line. the computer sees that your steering wheel is turned but your back wheels are moving at the same speed. normally this would only occur in a slide, so your computer compensates for a problem that isnt there!|
|08-26-2013 09:32 PM|
Take it back and make sure that they did the alignment correctly.. you should have about 1/8 inch tow in that usually stabilizes the steering. I would have them do a full 4wd alignment. If it is aligned then you should have them go over your front end to make sure everything is tight.
|08-26-2013 09:02 PM|
|08-26-2013 08:53 PM|
|HAFICON||Just hit a pothole at 50 mph almost lost control I had TNT truss installed With all new brackets, Still have stock control arms,|
|08-26-2013 08:44 PM|
It is not so much of a wandering issue As it seems the steering wants to stick Hard to explain
I now have a dash Light on Looks like a vehicle with skidmarks Cruise control will not work Horn will not work
|08-26-2013 08:43 PM|
|HAFICON||They were supposed to have done an alignment|
|08-26-2013 08:41 PM|
|HAFICON||4.88 Gears , truss, lockers, JKs quick disco|
|08-26-2013 08:18 PM|
Steering wheel off center won't cause wandering.
What else was done ?
You can recenter the wheel loosening the 2 turn buckle bolts on the drag link and rotating the sleeve. The procal only assist you.
|08-26-2013 08:11 PM|
Center steering wheel?
Just picked up my Jeep from shop an the steering wheel is off center Jeep is driving all I've the road. Can't I center I with my pro cal? I have I with me by do not see an option on the dip switch settings to do it
Thanks for replies I have a 4 hour drive ahead of me to get back home.