|08-28-2013 12:26 PM|
|08-28-2013 11:59 AM|
|OverkillYJ||1330 for 95 YJ, 1310 for others are what is on the yoke. Odds are you just need a 1310 ujoint. And Yeah, cut down those UBolt ends. Holy crap!|
|08-28-2013 12:32 AM|
|bajajohn||You are lucky that thing didn't decide to come loose while you were going at a high rate of speed it could have ben ugly.|
|08-27-2013 09:33 PM|
|Mowrangler||The rear joint on mine is a hybred 1330/1310 joint. But it is hard to tell by the pics.|
|08-27-2013 09:30 PM|
|Mowrangler||Take what is left of what you have to a driveshaft shop or NAPA and have them match it up. I cant tell by looking at the pics what you have. It could have been built with a couple different joints. 1330 and 1310 joints are common but who knows what the builder used ?|
|08-27-2013 09:10 PM|
|Hockeygeek21||So does anyone know what ujoint to use for the cv style driveshaft:|
|08-27-2013 09:05 PM|
It toreup the yoke,driveshaft t case output shaft and extension housing. Look at all of those closely before you put it back together.
|08-27-2013 09:02 PM|
|brachilius||While u r fixing the joint u might as well cut down the u-bolts! Just a thought.|
|08-27-2013 08:45 PM|
|08-27-2013 08:36 PM|
|08-27-2013 07:58 PM|
|Mbclark||What's going on over there on the other side of that u-joint?|
|08-27-2013 07:54 PM|
So I was driving in town today and heard some noise when I stopped, didn't think anything of it so I started going again and everything was shaking like crazy, limped home to find this.
Anyone know what ujoint I need? I have an sye with a cv style driveshaft, a link would be helpful, thanks.